Date post: | 08-Feb-2017 |
Category: |
Design |
Upload: | adam-jones |
View: | 485 times |
Download: | 2 times |
Materials used:
http://[email protected]
• Ruler• Permenant marker• Scalpel• Scissors• Plasticard• Template file (downloaded from site)
WARNING: Use a sharp scalpel and always cut on a cutting board or equivalent surface
Marking out the template:
http://[email protected]
• The template PDF prints to scale on a normal A4 sized page.• Place the template on the plasticard
and cut out the shapes. Over cutting the guidelines, and then trim them back makes the fit easier. • Some of the front armour plates are a
little thin, so cut out carefully to avoid breakage.
Preparing the Rhino:
http://[email protected]
• The Rhino APC comes with all sorts of bumps and doodads attached to said bumps. • The mountings for the headlights need to be
removed to fit the armour.• It is pretty straight forward work with
a scalpel and file.
Fitting the armour: http://[email protected]
• Perform a test fit to make sure it sits properly on the Rhino.• If the armour does not fit snugly, cut or file away some of the inside until
it fits snugly over the chassis of the Rhino• Fit and glue down the armour once
it fits properly• The spaced armour from Forgeworld is
another option. However, plasticard is cheaper and more accessible option and a lot more fun to play with!
For this and other awesome Wargaming
tutorials, reviews and guidesCheck out http://www.spruegrey.com