6
Date post: | 28-Mar-2016 |
Category: |
Documents |
Upload: | innovative-experiment-coltd |
View: | 216 times |
Download: | 0 times |
How To Equip Bluetooth to RQ-HUNO
1) Prepare “Bluetooth Board, Bluetooth Chip, 2s rivet, Cable”.
BluetoothBoard
BluetoothChip
2s rivet
Cable
2) Take out Battery. 3) Take out Chest Part.
4) Connect one side of Cable to Bluetooth Board. 5) Put through the one side of Cable tothe hole of Body part.
6) Make cable as shown above. 7) Insert cable to “COM” connector ofRQ Controller.
8) Insert 2s rivets to Bluetooth Board. 9) 2s rivets are inserted as shown above.
10) Put “Bluetooth Board” into “Body Part”. 11) You can see as show above.
12) Check Bluetooth Chip Pin connector well. 13) Insert Bluetooth Chip.
14) Cover “Chest Part” to Body Part. 15) Insert Battery as shown above.
16) Completed!