ME380 Fall 2015 Homework #2 Due – 9/22/15 For each problem submit the SolidWorks part files and a single PDF with images of the mass and inertia properties for each problem. Please label each file as LastName_FirstName_Prob#. Thus, for this homework you should have 4 files in total for submission. You may only submit once, so be sure to upload all documents correctly on the first attempt. 1) Origin is at the bottom in the center of the base. Use Nickel material.
Transcript
ME380 Fall 2015 Homework #2 Due – 9/22/15
For each problem submit the SolidWorks part files and a single PDF with images of the mass
and inertia properties for each problem. Please label each file as LastName_FirstName_Prob#.
Thus, for this homework you should have 4 files in total for submission. You may only submit
once, so be sure to upload all documents correctly on the first attempt.
1) Origin is at the bottom in the center of the base. Use Nickel material.
ME380 Fall 2015 Homework #2 Due – 9/22/15
2) Sketch on the front plane and extrude in the
positive Z direction so that the origin is on the
back side at the center of the brake rotor. Use
Malleable Cast Iron as the material.
ME380 Fall 2015 Homework #2 Due – 9/22/15
3) Edit the plastic container to have a handle and curved base like the part on the right. The
model is attached under the assignment in Blackboard. The handle is a 3/8x3/8 in square
cross section and defined by a circle centered as shown below. Fillets along the handle
are 0.1 in, at the base of the handle 0.2 in, and at the base of the container 0.5 in. The
handle is hollowed out to the same thickness as the container. Units are in inches.
