Date post: | 05-Aug-2015 |
Category: |
Devices & Hardware |
Upload: | pamela-pan |
View: | 42 times |
Download: | 3 times |
YOUR PARTNER OF VALVE & CONTROLS
Content
1. Cover2. Content3. Machining equipment (1)4. Machining equipment (2)5. Coating equipment6. Transmission housing machining7. Yoke machining8. Yoke connecting key slot machining9. Bad yoke10. Connecting block11. Spring housing12. Cylinder13. Accessories14. Test equipment (1)15. Test equipment (2)16. Test equipment (3)17. Summary18. Our philosophy19. Contact information
YOUR PARTNER OF VALVE & CONTROLS
Coating equipment
• Using marine paint, our process is: products preheating – undercoat – intermediate coat – finish coat – heat preservation
• This process made the paint with good adhesion & beautiful!
YOUR PARTNER OF VALVE & CONTROLS
Transmission Housing Machining
The raw material is GB QT-450-10 ductile iron, resin sand casting, well heat treatment; machining by DOOSAN horizon type machining center one clamping & one location, tolerance within 0.02mm.
YOUR PARTNER OF VALVE & CONTROLS
Yoke Machining
The raw material is GB QT-600-3 ductile iron, resin sand casting, well heat treatment; machining by DAHLI vertical type machining center, one clamping & one location, tolerance within 0.02mm.
YOUR PARTNER OF VALVE & CONTROLS
Yoke Connecting Key Slot Machining
In order to ensure the yoke’s connection key slot accuracy within 0.02mm, we adopt cut of WEDM, so that, user enable adjusting the install position between valve & actuator accordingly.
YOUR PARTNER OF VALVE & CONTROLS
Bad Yoke
• Inaccuracy machining, poor casting heat treatment might caused such kind damage! • Our actuators won’t have such kind problem.
YOUR PARTNER OF VALVE & CONTROLS
Connecting Block
We choose forged steel as raw material, finished by vertical machine center, one clamping
YOUR PARTNER OF VALVE & CONTROLS
Spring Container
Apparently our spring container have enough thickness, honed inner surface very smooth, spring seat with PTFE guide, enable spring working steady & reliable.
YOUR PARTNER OF VALVE & CONTROLS
Cylinder
We adept honing + chromate treatment process to ensure the cylinder’s roundness & wear ability. Of course, the raw material’s thickness also very important.
YOUR PARTNER OF VALVE & CONTROLS
Accessories
Accessary Our source
Spring Made by well know stated enterprise
Seal ring Imported from abroad
Grease Imported from abroad
YOUR PARTNER OF VALVE & CONTROLS
Our testing equipment (1)
• Tensile testing machine• Impact tester • CMM .
YOUR PARTNER OF VALVE & CONTROLS
Our Testing equipment (2)
• Auto welder• Vibration platform• Torque testing machine
YOUR PARTNER OF VALVE & CONTROLS
Our Testing equipment (3)
• Salt spray test chamber• High & low temperature
test chamber• Fatigue tester
YOUR PARTNER OF VALVE & CONTROLS
Summary
We have strict control from product’s design, martial selection, machining, heat treatment and actuator’s testing before shipment.
Our advanced equipment & management team made our actuators with very good quality, excellent performance and high cost-effective.
More than over, we also able to provide best solutions according to customer’s requirement!
YOUR PARTNER OF VALVE & CONTROLS
Contacts
Tel: 86 510 85590969Fax: 86 510 84088725Skype : respon_flow.controlEmail: [email protected]: www.respongroup.com
THANKS FOR YOUR TIME!