Hydra
Assembly instructions
Hydra Desk
Step 1
Remove the leg-cover panels.
Step 2
Remove the right panel from the main structure
Step 3
Anchor the Desk legs to the main structure; screw
direction indicated by the arrows
Step 4
Anchor the leg-support panel and screw it to the main
structure and legs
Step 5
Reposition the leg and main-structure cover-panels.
Tips and Tricks
Take off the bottom covers for easy cable routing
Depending on your configuration, you may need to move
the air-guidance vane
Use the provided mounting brackets for HDDs and
SSDs
Access the motherboard and PCI-E cables by
removing the back-panel; you can route cables via
the dedicated slot (Circled)
The legs also have a “cut” in them, designed for cable
routing
Use the cable-routing slots on the motherboard
tray and under the false-bottom for better cable
management.
For easier PCI-E positioning, remove the PCI-E cover
Use the provided caps to close off the mounting
holes in the leg
You can now position the rubber strip on the edge
of the desk
Once your build is complete, position the glass and
you’re done!