Hydra LEDPRODUCT SPECIFICATION
T: 01747 858100 | E: [email protected] | Page 1 of 6
INTRODUCTION
Using the latest Philips LEDs and drivers we are now able to offer an LED variant in our very successful Hydra range of
luminaires. The benefits of LED allow us to offer this luminaire in a wide range of lumen outputs with light output ratios in
excess of 90% combined with a 5 year warranty (subject to terms and conditions, please see our warranty page for full
details).
The Hydra LED can also be offered in a range of dimming variants and with integral three hour emergency. We supply the
Hydra LED with stainless steel clips and screws as standard in order to ensure that the luminaire has tooled access in
compliance with regulations.
The Hydra LED is ideally suited to industrial applications where protection from dirt and dust ingress and light impact is
essential, especially in areas where access is difficult and the cost of maintaining traditional fluorescent sources is high and
is suitable for use in applications where the temperature ranges from -20°C to +25°C.
APPLICATION
Corridor
Exterior
Food/Clean Area
Healthcare/Social Housing
Hotel/Leisure
Industrial/Manufacturing
Hydra LEDPRODUCT SPECIFICATION
T: 01747 858100 | E: [email protected] | Page 2 of 6
Parking/Exterior
Retail
Stairwell
Store Room
Transport
Warehouse/Storage
SPECIFICATION
Construction
Glass reinforced polyester housing.
Polycarbonate diffuser.
Steel gear tray powder painted white.
Stainless steel diffuser clips as standard.
Ip65 rated.
Performance
Light output ratio of 90%
Up to 140 luminaire lumens per circuit watt.
Control
Available with Switch dimming, DALI dimming, HFR 1-10v Analogue dimming and Digital dimming.
Emergency
Available with standard, self test and autotest dimming.
Installation
Suitable for chain suspension (please specify additional Eye Bolt Kits if required).
Suitable for trunking mounting via four knock out positions in the rear of the housing.
Suitable for conduit entry through 20mm apertures in luminaire ends.
IMAGES
Product Images
Hydra LEDPRODUCT SPECIFICATION
T: 01747 858100 | E: [email protected] | Page 4 of 6
TECHNICAL
CP-37-0001.PDF CP-37-0003.PDF
CP-37-0004.PDF CP-37-0022.PDF
WARRANTY
All Dextra products are supplied with a 12 month warranty for any defect that may occur with the product during this time.
Hydra LEDPRODUCT SPECIFICATION
T: 01747 858100 | E: [email protected] | Page 5 of 6
Any defect will either be repaired on site free of charge or the defective product may be replaced on a chargeable basis and
credit given against defective product returned. The course of action taken will be at our discretion and dependent on the
nature of the defect.
The control gear within our high frequency and LED luminaires is further underwritten by our suppliers for a period of up to 5
years in total from the time of purchase. This comprises labour and parts for the first 3 years and free of charge components
only for the final 2 years.
PROTEC LED FR 8W GU10 variants and Emergency LED ranges are exempt from the 5 year warranty and are supplied with
1 year warranty only. PROTEC LED COB luminaires are supplied with a two year warranty for replacement luminaires only.
All warranties are subject to correct use of the product and will be invalidated by misuse, for example incorrect installation or
unsuitable environmental conditions.
It is the duty of the customer to ensure that all relevant tests have been carried out prior to requesting site visits or
replacement products, for example replacement of lamps, commissioning of sensors and inspection of external wiring. In the
event that no defect is found with the product our costs for attending site will be recharged to the customer and credit will not
be issued against returned products.
No consequential losses incurred resulting from any defect with our product will be reimbursed.
Consumable commodities such as lamps, starters and batteries are excluded from these warranty terms. Batteries are
supplied with a twelve month warranty only.
5 year warranty on LED product ranges is subject to a maximum of 4000 operating hours per year and only applies where
failures exceed the component manufacturers expected failure rate and lumen depreciation.
If you require any assistance with regards to our products please do not hesitate to contact our Customer Services
department on 01747 858100.
ORDER CODES
Luminaire Codes
Code Description Circuit Wattage Llm/w
HYD L22 PC 2S Hydra LED, 600mm Single Body, 2200 Lumen, Polycarbonate Cover, Colour 84 16.3w 133
HYD L26 PC 4S Hydra LED, 1200mm Single Body, 2600 Lumen, Polycarbonate Cover, Colour 84 18.0w 134
HYD L38 PC 4S Hydra LED, 1200mm Single Body, 3800 Lumen, Polycarbonate Cover, Colour 84 26.8w 132
HYD L87 PC 4T Hydra LED, 1200mm Twin Body, 8700 Lumen, Polycarbonate Cover, Colour 84 56.7w 138
HYD L35 PC 5S Hydra LED, 1500mm Single Body, 3500 Lumen, Polycarbonate Cover, Colour 84 23.1w 141
HYD L45 PC 5S Hydra LED, 1500mm Single Body, 4500 Lumen, Polycarbonate Cover, Colour 84 30.3w 138
HYD L54 PC 5S Hydra LED, 1500mm Single Body, 5400 Lumen, Polycarbonate Cover, Colour 84 36.1w 139
HYD L63 PC 5S Hydra LED, 1500mm Single Body, 6300 Lumen, Polycarbonate Cover, Colour 84 42.1w 139
HYD L96 PC 5S Hydra LED, 1500mm, Single Body, 9600 Lumen, Polycarbonate Cover, Colour 84 63.4w 136
HYD L132 PC 5T Hydra LED, 1500mm Twin Body, 13200 Lumen, Polycarbonate Cover, Colour 84 90.6w 131
C83 option available on special request with specific lumen outputs.Suitable for applications where the temperature ranges from -20° to +25°, Emergency versions not suitable for applicationsbelow 0°
Dimming & Lighting Gear
Code Description
H* High Frequency Dimming (Analogue 1-10v)
Hydra LEDPRODUCT SPECIFICATION
T: 01747 858100 | E: [email protected] | Page 6 of 6
S* Switch Dimming
A* Digital Addressable Lighting Interface (DALI)
D* Digital Dimming (DSI) ECO**
C Bi-Level Dimming
**Not available for the L26 version.
Emergency
Code Description
E3 3 Hour Integral Emergency
ST3 Self Test
AT3 Autotest Emergency
Miscellaneous
Code Description
TRS Tamper Resistant Screws
C2240 Eyebolt Suspension Kit
All Hydra LED luminaires are supplied with a full set of stainless steel clips, 4 of which are screw retained.