Hydraulic FracturingHydraulic Fracturing
Xiaofeng Liu, Assistant Professor
Department of Civil and Environmental Engineering
University of Texas at San Antonio
http://engineering.utsa.edu/CE/Liufac.html
Email: [email protected]
What is hydraulic fracturing?
• Also called “fracking”
• A process of initiating, and subsequently
propagating a fracture in a rock layer, by
injecting the pressurized fluidinjecting the pressurized fluid
• The fracturing is done from a wellbore drilled
into reservoir rock formations, in order to
increase the extraction and ultimate recovery
rates of oil and natural gas
2
ww.propublica.org 3
4
What is shale
• Shale is a fine-grained sedimentary rock composed of mud and tiny fragments of other minerals
• Shales are typically deposited in very slow moving water and are often found in lakes and lagoonalwater and are often found in lakes and lagoonaldeposits, in river deltas, on floodplains and offshore from beach sands.
• Shale is characterized by breaks along thin laminae or parallel layering
• Usually has low permeability
5
6
Limestone on shale.
7
Source: wikipedia 8
9
Source: US DOE10
11
12
A well head at a fracking operation near Carrizo Springs, TX
Source: SA Express News 13
Chesapeake Energy hydraulic fracturing operation over the Eagle Ford shale
formation near Carrizo Springs
Source: San Antonio Express News14
An employee of Cheapeake Energy pours a chemical mixture called
cross linked gel that is mixed with sand and used in the hydraulic
fracturing process
Source: SA Express News15
How does hydraulic fracturing work?
• Three steps:
– Pump the fracturing fluid into the wellbore at a rate sufficient to increase the pressure downhole to a value in excess of the fracture gradient of the formation rock.
– The pressure causes the formation to crack, allowing the – The pressure causes the formation to crack, allowing the fracturing fluid to enter and extend the crack farther into the formation.
– To keep this fracture open after the injection stops, a solid proppant, commonly a sieved round sand, is added to the fracture fluid. The propped hydraulic fracture then becomes a high permeability conduit through which the formation fluids can flow to the well.
16
• Injected fluid: water, gels, foams, and
compressed gases, including nitrogen, carbon
dioxide and air
• Proppant: sand, resin-coated sand, and man-
made ceramics
17
How much water needed?
• A multi-stage fracturing of a single horizontal shale gas well can use several million gallons of water– Compare with: 70 gallons per capita per day in US
– San Antonio has a population of 1.5 million, consumes – San Antonio has a population of 1.5 million, consumes 38,325 million gallon per year
– According to DOE by All Consulting, Marcellus shale production consumes 20,150 million gallon per year
• Most water used in hydraulic fracturing comes from surface water sources such as lakes, rivers and municipal supplies.
18
How is the water handled? With care?
19
20
21Source: http://www.mahometaquiferconsortium.org
22
http://www.mahometaquiferconsortium.org
Hydraulic FracturingHydraulic Fracturing
Xiaofeng Liu, Assistant Professor
Department of Civil and Environmental Engineering
University of Texas at San Antonio
http://engineering.utsa.edu/CE/Liufac.html
Email: [email protected]
