FEATURES
• Cost effective
• Micro-processor control
• Small footrint & compact size
• Din rail mounting
• Automatic multi-stage charging
• Continuously rated
• Protections: - Short circuit and overload - Over voltage - Over temperature - Reverse battery
• Universal AC input range
• Low ripple output
• Naturally cooled
• Simple calibration procedure
• Comprehensive alarm monitoring
• Fail alarm contact set
APPLICATIONS
• Standby & prime power generators
• Engine driven pumps and compressors
• Switch gear tripping
• Industrial control systems
• Robust PSU
• Alarm systems
• Navigational aids
iCharge Automatic Battery Charger
www.meccalte.com
iCharge automatic battery chargers provide a cost effective solution to most industrial battery charging requirements.
Utilising the latest high efficiency switch-mode technology and micro-processor control, the range is suitable for charging most sealed or flooded batteries and is easily calibrated by the end user to suit the battery type. The multi-stage intelligent charging characteristic ensures accurate and efficient battery charging and is designed for permanent connection to the batteries maintaining them in a fully charged condition without overcharging.
The iCharge is fully protected against overload, reverse battery connection, over voltage and over temperature.
INPUT SPECIFICATION
Voltage range, VIN
100 - 264V AC
Frequency 47 - 63Hz
Input current 2.5A max.
Leakage current <1mA / 240VAC
OUTPUT SPECIFICATION
Voltage / CurrentOther voltages on request
24.0V Nominal 10A.
Ripple and noise ±0.5%
Line regulation ±0.5%
Load regulation ±1.0%
Efficiency Up to 88%
Overload protection Constant current limit
Over temp. protection Output shutdown with automatic recovery
Reversed battery protection
Automatic protection.Disabled when in PSU mode.
ALARMS AND LEVELS
DC output voltages Float = Factory set to 27.6V.Boost (Bulk/Absorb) = Float Voltage +4%.
AC / charger fail Loss of AC input or DC output voltage control
Low DC voltage alarm Float voltage -12% alarm, -8% Reset
High DC voltage alarm Float voltage +7% alarm, +5% Reset
Over voltage protection 30.5 Instantaneous lockout
Battery disconnected Open circuit on DC output (Disabled in PSU mode)
MAS 1024R 24V-10A
DS-399/1
iCharge
ISOLATION
Withstand voltage Input - Output, input - Earth 1.5kV AC
Isolation resistance Input - Output, input - Earth, Output - Earth 500V DC / 100M Ohms
ENVIRONMENTAL SPECIFICATION
Working temperature -10ºC to +50ºC
Working humidity 20 - 90% RH
Storage temperature -20ºC to +85ºC
Storage humidity 10 - 95% RH
Unpacked weight 1.2 kgs
FINISHAluminium / RAL9005 black fine texture
FAIL ALARM RELAY CONTACT SET (OPTIONAL)Volt-free form C relay contact set for signalling of a fault alarm condition. The relay contacts de-energise 60 seconds after a fault occurs. The over voltage protection shutdown alarm de-energises the contacts instantly.
GENERAL ARRANGEMENT
TERMINATIONAC input and DC output: Connections terminate to rising clamp screw terminals and will accept 6.0mm2 stranded cable.
Fail alarm: Connections terminate to rising clamp screw terminals and will accept 2.5mm2 stranded cable.
Connector ‘C1’ (signals): Pins 7 and 8 should be linked when the charger should also function as a PSU.
NOTE: Reverse battery and battery disconnected alarms are disabled in PSU mode.
The remaining pins are for expansion modules, communication interfaces, firmware upgrade etc. and should not be used.
ORDERING INFORMATION
Model No. DC output
MAS 1024R 24V-10A 24V 10A
www.meccalte.com
Top-hat din rail mount