IETF

draft-jeyatharan-mext-flow-tftemp-reference-00 draft-jeyatharan-mext-flow-tftemp-reference-00

Mohana Jeyatharanmohana.jeyatharan@sg. panasonic.comChan-Wah Ngchanwah.ng@sg.panasonic.com

1

IETF

AgendaAgendaBackground on Flow Filtering via BearersFlow Binding Operation in 3GPP SAEMotivation for using TFT as traffic selectorObjective of this workOverview of Flow Binding Operation with TFT Impact of TFT state change on Flow Binding

RulesTFT Reference Traffic Selector Sub OptionWay Forward

2

IETF

Background on Flow Filtering via Background on Flow Filtering via BearersBearers

Flow filtering via 3GPP Bearers:◦ For improved QoS, one or more dedicated

bearer creation initiated by P-GW◦ B1->default bearer◦ B2 ->dedicated bearer

◦ Each dedicated bearer (and in some cases default bearer) assigned a TFT

◦ B1-> packet filter 1, packet filter 2◦ B2-> packet filter 3, packet filter 4

◦ Data flow that can be matched to a packet filter of TFT, is attached with appropriate Bearer ID

◦ Data packet matching Packet filter 3 has B2 attached to it

◦ Bearer ID embedded in data packet, helps the gateways to identify the needed QoS treatment

3

P-GW

S-GW

Bearer ID 1(B1)[packet filter 1, packet filter 2]->TFTBearer ID 2(B2)[packet filter 3, packet filter 4]->TFT

Flow Filtering to

Bearer Performed

B1(Prefix1)

B1

B1

B2(Prefix1)

B2

B2

eNB

MN

Bearer filter Table1

2

1

2

3

3

Default access

Flow Binding in 3GPP SAE for Flow Binding in 3GPP SAE for Simultaneous AccessSimultaneous Access

P-GW supports flow filtering to interface and flow filtering to bearers

If WiFi access is default access, MN will send flow binding BU to ensure flows tied to packet filter 3 and packet filter 4 receive QoS

P-GW filters only data flows tied to Packet filter 3 and packet filter 4 via 3G

During 3G filtering, flows tied to packet filter 3 and packet filter 4 will be filtered to bearer B2

4

P-GW

S-GW

B1

B1

B1

B2

B2

B2

e-PDG

eNB

MN

HoA, BID1, CoA(HoA), FID1, Packet filter 3HoA, BID1, CoA(HoA), FID2, Packet filter 4HoA, BID2, CoA(WiFi CoA), ->Default Access

Bearer ID 1(B1),[packet filter 1, packet filter 2]->TFTBearer ID 2(B2),[packet filter 3, packet filter 4]->TFT

3G(Home Link)/HoAWiFi/CoA

IPv6 filtering

Bearer filtering

1

1

Flow binding BU : BID1, FID1, FID2, BID2 2 2

3

3

Flows tied to packet filters 3

and 4 are attached with

B2

Motivation for using TFT as Motivation for using TFT as Traffic SelectorTraffic Selector All packets, filtered to 3G interface at the IPv6 layer will need

to match Packet filters of TFT. Otherwise packet loss can occur.

Sending Reference to TFT in flow binding solves this issue

P-GW has packet filters with appropriate descriptions stored. Thus, flow binding BU need not have explicit flow descriptors in the traffic selector sub-option.

Using TFT as traffic descriptor, reduces flow binding BU packet size

If new packet filters are added to a TFT by P-GW, only a refresh flow binding signal is sufficient rather than sending a new flow binding BU for the new packet filters created.

Reduces flow binding signaling and saves battery power of MN

If packet filters are removed from the TFT, again only a single refresh flow binding BU is necessary rather than performing removal for multiple packet filters.

Reduces flow binding signaling and saves battery power of MN

ObjectiveObjective of this Work

To propose a new Traffic Selector format to be used for the Traffic Selector Sub-option proposed in the MEXT flow binding draft

Introduce a new traffic selector sub option format in parallel to the currently available binary traffic selector format, to address flow binding in a 3GPP specific scenario

Introduce a new format value for the TS field of the traffic selector sub option and use a new data field value for the traffic selector field

Overview of Flow Binding Operation Overview of Flow Binding Operation with TFTwith TFT Creating Flow Binding Rules

TFT Reference as a new traffic selector format

BU formed with TFT Reference Traffic selector sub-option attached to FID option

Bulk flow binding BU sent and entries created

Refreshing Flow Binding Rules◦ Same as in MEXT Flow

binding draft.

Deleting Flow Binding Rules◦ Same Operation as in MEXT

Flow binding draft.

7

IPv6 HeaderBU Mobility Header

Mobility OptionsBID2 option (care of binding for WiFi)BID1 option (care of binding for 3G)

FID1 Option[TFT reference traffic selector sub-option ->Bearer ID2]

P-GW

S-GW e-PDG

HoA, BID1, CoA(HoA), FID1, Bearer ID2HoA, BID2, CoA(WiFi), ->Default Access

Bearer ID 1(B1),[packet filter 1, packet filter 2]->TFTBearer ID 2(B2),[packet filter 3, packet filter 4]->TFT

3G WiFiMN

Flow binding BU w TFT

Ref

P-GW flow binding table with TFT Ref

Flow Binding BU with TFT Ref

1

22

2

1

Impact of TFT State Change on Flow Impact of TFT State Change on Flow Binding Rules with TFT ReferenceBinding Rules with TFT Reference

Creation of TFT by P-GW◦ MN will send Flow binding BU with TFT ref in traffic selector

sub-option if MN wants packet filters tied to new TFT to be sent via 3G and receive appropriate QoS

Changing TFT by P-GW◦ If new packet filter added to TFT, MN may perform Refresh

Flow binding BU as in MEXT flow binding draft to get adequate QOS for new packet filter

◦ If packet filter is removed from a TFT, MN may perform Refresh Flow binding BU as in MEXT flow binding draft and decide to send the flows tied to deleted packet descriptors via the default path (WiFi)

Removal of TFT by P-GW◦ MN needs to send flow binding deletion BU as in MEXT flow

binding draft if MN decides the flows tied to deleted TFT need not traverse via the 3G interface

TFT Reference Traffic Selector Sub TFT Reference Traffic Selector Sub OptionOption

9

Sub-opt TypeSub-opt LenTS format Reserved

TFT Ref

Sub-opt Type: assigned to 3 as in MEXT Flow Binding DraftSub-opt Len: Total length is 3 octets for this sub-optionTS Format: Needs to be assigned by IANA to highlight TFT refTraffic Selector formatReserved: Set to 0TFT Ref: 8 bit field to carry the Bearer ID

Way ForwardWay Forward

Are people convinced that the TFT Reference TS format is useful to be applied in 3GPP scenario?

Do people think, that this TFT Reference format is a needed work and IETF should do it?

Any possibility of adopting it as a WG item?

10