Comba Telecom Inc. 568 Gibraltar Drive, Milpitas, CA 95035. http://www.combausa.com/ Tel: +1 866 802 7961, [email protected], Fax: +1 408 526 0181
Information contained in this document is subject to confirmation at time of ordering. Specifications may differ depending on region and customers’ requirements
Page 1 of 2 DS-Control 0-0-1/ 1018
Indoor Wide Band Omni Antenna IXD-360H04MJN-ADR 698-2700MHz, N-Female
• Omni antenna wideband covering 698-2700MHz(700/800 Public Safety Band, 2G/3G/4G Network)
• Low Profile and suitable for Indoor application• Compact ceiling mount and cost-effective design• Radio Frequency Identification tag preinstalled to
communicate with the CriticalPoint™ Antenna Monitoring System
Horizontal Vertical
698MHz 806MHz 880MHz 960MHz
1695MHz 2170MHz 2300MHz 2700MHz
Electrical Specification Product Model IXD-360H04MJN-ADRFrequency (MHz) 698-806 806-960 1695-2700 Gain (dBi) 2.2 ± 1.0 3.5 ± 1.0 4.5 ± 1.0 Polarization Horizontal Beamwidth Horizontal (°) 360 VSWR ≤ 1.5 ≤ 1.5 ≤ 1.5 PIM (dBc) < -153@2 x 43dBm Average Power, max (W) 50 Impedance (ohm) 50
Mechanical Specification Environment & Compliance Dimension Diameter, height (in/mm) ∅ 8.7x 0.7 / ∅ 220 x 18 Application Indoor Weight (lb/kg) 0.7 / 0.3 Operating Temperature -35°C to +85°CShipping Dimension(in/mm) 8.9x8.7x3.6 / 225x220x90 Relative Humidity Up to 95%Shipping Weight(lb/kg) 1.1/ 0.5 RoHS Compliant Radome Material & color ABS, White, RAL9003 Mounting Ceil Mount Connector type N-Female
Antenna Pattern
Comba Telecom Inc. 568 Gibraltar Drive, Milpitas, CA 95035. http://www.combausa.com/
Tel: +1 866 802 7961, [email protected], Fax: +1 408 526 0181 Information contained in this document is subject to confirmation at time of ordering. Specifications may differ depending on region and customers’ requirements
Page 2 of 2 DS-Control 0-0-1/ 1018
Method 1:
Make a hole with a hole punch or drill
Hole Size ≥ 0.8 [18.0]
Lock Nut
Unit : inch [mm]
Method 2:
Stick on the stickers
Drill three holes as shown the picture
Hole Size ≥ 0.23 [6.0]Put the plug in the hole
Tighten the screw (M4x25mm)Cover the lid
Mechanical Drawing and Installation Guide