Installation guide PSTI Series Photonplay

Installation GuideTickerplay LTI Series

Installation GuideTickerplay

(PSTI Series)

[email protected]

Photonplay Sytems Inc. | www.photonplay.com

1

mailto:[email protected]


Contents1. Parts List2. Required3. Tools 4. Installation Steps

Parts List

1. Ticker Bar

2. Z-Bar

3. L-key nut

4. L-key driver

Ticker Bar

Quantity: 3


2


Fish Plates

Quantity: Straight-4, Purpose: To be put on joint of the ticker and the corner where the two tickers meet.

Z-Bar


3

Straight Fish Plate


Quantity: -3

Purpose: To be fixed on the wall and the ticker will be hung on it like a photo frame

L Key Bolt

Quantity: ……….

Purpose: Required to join together Fish Plates and ticker chassis on joints

L Key Bolt Driver

Quantity: 1-2

Purpose: Driving the L Key bolts.


4


Tools RequiredSr no Item Picture

1. PVC Gitti


5


2. Wall Screws

Installation Steps

Step 1

Unboxed the ticker and look for all the parts listed above

Step 2

1. Unboxed the 1 cardboard box. 2. Open the cardboard boxes and separate all the tickers by opening up the thin sheet

wrap around them and keep them on the ground or any appropriate surface.

3. Look for the ticker from where the AC wire for the power must be hanging as shown below. Keep in mind that the ticker will be positioned in this position as shown and will be hung up.


6


1st Ticker Bar.

Step 3 – Socket Side To cover the wall of 189 inches

1. Look for the one ticker bars which are 63 inches in length, 2nd And 3rd is also same length and connect with the all 3 ticker joint bar which are 63+63+63=189 inches in length. All are Power socket side ticker war length.


7


Before mounting, remember to cross check if all the joints and the fixes of the wires and the ticker are properly done by switching on the power supply and checking the ticker.

1. After all the jointing and fixing, your ticker would something look like this .


8



9


Step 4 Now, the ticker installation is complete. Now, we will hung the ticker on the wall.

1. Fixing Z-Bar on the wall

Step 5

Place the ticker on the Z-Bar fixed on the wall


10



11


After your ticker is hung on the wall, it will look something like the pictures shown below as one of our previous installations.


12


Now finally ticker installation is complete!!!

Plug in the Ticker to AC supply and enjoy streaming Stock Updates.

Write us in case of any clarification required on installation at [email protected]


13

RegardsLarry and Ash

Sales and Customer SupportTickerplay Signs [email protected]

mailto:[email protected]



14

Date post:	14-Apr-2017
Category:	Technology
Upload:	james-william
View:	169 times
Download:	1 times

Installation guide PSTI Series Photonplay

Technology