INSTEON Thermostat2441TH Quick Start Guide
INSTEON Thermostat
SET
72
SET
Mode
Set Button
Temperature Adjust
Status LED
For the complete Owner’s Manual and more, visit: insteon.com/support
Phillips Screwdriver
Small Phillips Screwdriver
Small Flathead Screwdriver
Tools Needed for Installation
Disconnect PowerAlways disconnect power before installation. Contact INSTEON Support when uncertain about installation.
1-866-243-8022
Installation
ON
ON
ON
ON
ON
ON
ON
OFF
ON ON
Circuit Breakers
Power is OFF
Fuse Panel
or
1 Turn off power to your air conditioning system at the electrical service panel.
Power is ON
2 Remove your old thermostat. Some are secured with screws, others tilt upwards.
W1/O/BW2
M1SC1
RS2M1SC3
RS+5
RS1RS GND
Y1
GM1SC2
CK1
CK GND
RC
3 Verify that the INSTEON Thermostat will work with your air conditioning system. Heat pump and line voltage systems are incompatible.
W1/O/BW2
M1SC1
RS2M1SC3
RS+5
RS1RS GND
Y1
GM1SC2
CK1
CK GND
RC
X
4 Take a picture of your wiring and label the wires using the included labels. When ready, remove the old thermostat’s mounting plate.
W1/O/BW2
M1SC1
RS2M1SC3
RS+5
RS1RS GND
Y1
GM1SC2
CK1
CK GND
RC
W1/O/BW2
M1SC1
RS2M1SC3
RS+5
RS1RS GND
Y1
GM1SC2
CK1
CK GND
RC
5 Mount the INSTEON Thermostat and connect the wires to the corresponding wire terminals.
Wire color may vary
Y1
Y2
24COM24R
W1
W2
G
Y1
Y2
24COM24R
W1
W2
G
Y1
Y2
24COM24R
W1
W2
G
Y1
Y2
24COM24R
W1
W2
G
Y1
Y2
24COM24R
W1
W2
G
Y1
Y2
24COM24R
W1
W2
G
6 Close the Thermostat cover and turn on power from the service panel. Your INSTEON Thermostat will calibrate and is now ready for use.
Installation complete. You can now link your Thermostat to the Hub.
SET
When prompted, press and hold the set button on your Thermostat.
Follow the on-screen instructions to add the Thermostat to your INSTEON Hub.
Linking to the Hub
+
If not using the Hub, refer to the instructions that came with your product.!
With the Hub, follow the instructions below to change the temperature mode of your thermostat.
Use ºF or ºC
PROGRAM
PROGRAM
PROGRAM
PROGRAM
Thermostat
Name
Icon
Room Memberships
Humidity
Units ºFºF
ºC
If not using the Hub, refer to the instructions that came with your product.
Linking complete. You can now control your Thermostat from the App.
RAW-1301 Rev 03.13.14
Without the Hub, follow the instructions below to change the temperature mode of your thermostat.
ºC
3x
ºF
Use ºF or ºC
PROGRAM
F
PROGRAM
C
PROGRAM
72
PROGRAM
22
PROGRAM
PROGRAM
MODE
Protected under U.S. and foreign patents (see www.insteon.com/patents)©2014 INSTEON