Instruction ManualWhite/OrangeOrange
White/GreenGreen
White/GreenGreenBlueWhite/Blue
BlueWhite/Blue
White/BrownBrown
White/OrangeOrange
White/BrownBrown
12364578
TIA / EIAT568B
YellowOrangeWhiteBlue
INDUSTRIALTIA / EIAT568A
Fan out all four twisted pairs, following the color coding label and allocate each conductors into proper slots on wiring cap.Trim the ends of conductors.
1
Remove the wiring label before place wiring cap on plug.
Place the wiring cap onto plug, use plier to clamp wiring cap until it completely snap-in to e�ect the connection.
Close plug cover, make sure the drain wire is in proper contact with grounding clip on plug. Pull back strain relief boot to cover the plug, fasten supplied cable tie to secure grounding contact.
3
4
6
5
Drain Wire
Cable Tie
Insert cable into strain relief boot, strip o� 1.2 inch of cable jacket, fold back the drain wire.
2
Remove the stopper before installation. Cover Stopper
Open shielded cap
Cut o� cable tie, remove the boot. Using �at screw driver and pry gently on plug cover one end �rst and the other end subsequently to open it.
Unload the cable
Cut the end of boot to �t your cable OD.Boot adjustment
Cut o� cable tie
Wiring Label
Remove boot
1.2"(30mm)
MontageanleitungWeiß/OrangeOrange
Weiß/GrünGrün
Weiß/GrünGrünBlauWeiß/Blau
BlauWeiß/Blau
Weiß/BraunBraun
Weiß/OrangeOrange
Weiß/BraunBraun
12364578
TIA / EIAT568B
GelbOrangeWeißBlau
INDUSTRIALTIA / EIAT568A
Adern entsprechend dem Farbcode in dieManagementbar einführen und kurz abschneiden.
1
Wiring Label entfernen .
Managementbar im Stecker positionieren und mit einer Zangefest verpressen, bis die Managementbar einrastet.
Steckerklappe schließen.Kabel mit Kabelbinder �xieren. Tülle über den Stecker schieben. Fertig!
3
4
6
5
Kabelbinder
Kabel durch die Hülle schieben. Kabel-mantel auf einer Länge von ca. 30 mmentfernen.
2
Stopper entfernen. Stopper
Steckerklappe ö�nen
Ö�nen des Steckers
Um die Tülle an größere Kabeldurch-messer anzupassen, entsprechend kürzen!
Kabelbinderdurchschneiden
Wiring Label
Tülle nachhinten schieben
1.2"(30mm)