Document No: S21.IPCS‐0016 Issue: 5 Dated: 12 th February 2019 BOEING B737‐400 Illustrated Parts Catalogue for Aircraft Embodied With: INTRODUCTION OF MECHANICAL PROVISIONS FOR THE INSTALLATION OF CARRIAGE OF ANIMALS STC Twenty One Limited The Waldorf Centre 1290 London Road Alvaston Derby DE 24 8QP United Kingdom The technical content of this document is approved under the authority of DOA nr. EASA. 21J.198 The copyrights of this document are reserved by STC Twenty One Limited. It is provided in confidence on the condition that it is not copied, reproduced or disclosed either wholly or in part, without the consent, in writing, of STC Twenty One Limited. It is supplied in confidence, and commercial security on its contents must be maintained. It must not be used for any purpose other than for which it is supplied, nor may information contained in it be disclosed to unauthorised persons. It must not be reproduced in whole or in part without permission in writing from the owners of the copyright.
Transcript
Document No: S21.IPCS‐0016 Issue: 5
Dated: 12th February 2019
BOEING B737‐400
Illustrated Parts Catalogue for Aircraft Embodied With:
INTRODUCTION OF MECHANICAL PROVISIONS FOR THE INSTALLATION OF CARRIAGE OF
ANIMALS
STC Twenty One Limited The Waldorf Centre 1290 London Road
Alvaston Derby DE 24 8QP United Kingdom
The technical content of this document is approved under the authority of DOA nr. EASA. 21J.198
The copyrights of this document are reserved by STC Twenty One Limited. It is provided in confidence on the condition that it is not copied, reproduced or disclosed either wholly or in part, without the consent, in writing, of STC Twenty One Limited. It is supplied in confidence, and commercial security on its contents must be maintained. It must not be used for any purpose other than for which it is supplied, nor may information contained in it be disclosed to unauthorised persons. It must not be reproduced in whole or in part without permission in writing from the owners of the copyright.
To: All holders of this STC Twenty One Limited Document This Illustrate Parts Catalogue Supplement is provided in electronic format (PDF). This should be filed together with the affected manual(s) IAW the operator’s approved procedures for technical publication filing and retention. In the event that the Illustrate Parts Catalogue Supplement is revised, it will supersede any previous revisions in their entirety and any previous revisions should be disregarded. Record the embodiment of above referenced Technical Publication and date of insertion on the Record of Supplements/Revisions. This should be filed together with the affected manual(s) IAW the operator’s approved procedures for technical publication filing and retention. This Manual Revision/Supplement is true and accurate at the time of issue. This revision/supplement is issued by STC Twenty One Ltd and complies with relevant EASA requirements. Any further changes to the aircraft affecting these publications should be reported to STC Twenty One Ltd.
STC Twenty One The Waldorf Centre, 1290 London Road, Alvaston, Derby, UK, DE24 8QP Fax: +44 (0)1332 576831 Email: [email protected]
Maintenance Reporting Form Deal with One Subject Only
Name: Position:
Contact Telephone No.: Contact Email:
Question/Suggestion
Date: Change/Repair Number: S21.25‐13‐1665 Use this form to notify STC Twenty One Limited of any difficulties or problems associated with the information contained within this Supplemental Manual.
Addition of MSN’s 25105, 25110, 25111 Update to : CHAPTER 11 FIG 1. ITEMS 12 & 13 PART NUMBERS AMENDED CHAPTER 25 FIG 1. ITEMS 41 & 42 ALT PART NUMBER LISTED CHAPTER 25 FIG 2. ITEM 41 ALT PART NUMBER LISTED CHAPTER 25 FIG 5. ALT POSITION OF ITEM 2 AND ITEM ‐31 ADDED
3 19/07/2018 CHAPTER 11 FIG 1. ITEM 11 AMENDED TO PCBM‐39897 Addition of MSN’s 25097, 28886, 28892, 28893, 29270 to applicability table.
4 18/01/2019 Chapter 25‐00, Figure 4, item 22 part number changed to read MS20426AD4‐5
5 12/02/2019 Chapter 25‐00, Figure 5 updated to reposition lead animal hander panel.
INTRODUCTION OF MECHANICAL PROVISIONS FOR THE INSTALLATION OF CARRIAGE OF ANIMALS ................................................................................................................................... i
1. TRANSMITTAL NOTICE .................................................................................................................... ii
2. MAINTENANCE REPORTING FORM ............................................................................................... iii
3. APPROVAL SHEET ........................................................................................................................... v
4. RECORD OF REVISIONS ................................................................................................................. vii
This Illustrate Parts Catalogue Supplement (IPCS) has been created to list the Line Replaceable Units (LRU’s) introduced by Design Change S21.25‐13‐1665. Each section / chapter identifies the location and part number of LRU’s, broken down into ATA 100 chapters for inclusion into existing Aircraft Manuals. Items such as screws washers, bolts etc. are not normally illustrated. Revisions or amendments by other approved organisations must be separately certified and recorded on separate record sheets.
B) How to use IPCS Tables
The first line at the beginning of the table is called the figure title and corresponds with the title of the figure appearing in the previous page(s). The tables (parts list) consist of six columns:
a) FIG ITEM ‐ This is the item called out on the corresponding illustration. Numbers preceded by
a dash are not illustrated.
b) PART NUMBER ‐ This is the part number assigned by the vendor.
c) SUPPLIER – If identified this will show the company name of the manufacturer/supplier of the
part/unit.
d) NOMENCLATURE ‐ This is a description of the part.
e) EFFECT FROM TO ‐ If the IPCS is written for more than one aircraft, this column indicates in
which aircraft the part is located. If All aircraft in the design change are covered the word ALL
will appear in this column.
f) UNITS PER ASSY ‐ This is the quantity of the part.
(a) (b) (c) (d) (e) (f)
FIG. ITEM PART NUMBER SUPPLIER 1 2 3 4 5 6 7 NOMENCLATURE EFFECT
FROM TO
UNITS PER ASSY
1. Installation of XXXXXXX ALL RF
5 10000000‐23 COMPANY A
‐6 10000000‐26 *
‐ ITEM NOT ILLUSTRATED *STANDARD INDUSTRY PART/UNIT
Note: If an item is not shown in an illustration then a “‐“ will be next to the FIG. ITEM number to
identify that it is intentionally not in the diagram, however is required for installation.
C) Applicability/Effectivity This IPCS is effective to the following Manufacturer’s Serial Numbers:
24440 25097 25105 25110 25111 25147
28886 28892 28893 29202 29203 29270
For clarity, the effectivity of each diagram is given in manufacturer’s serial number in the footer of each page. When the page is valid for all the aircraft in the customer fleet, the effectivity statement is "A/C ALL". When the diagram is not valid for the whole fleet but for certain aircraft only, the effectivity statement gives the aircraft for which it is valid in MSN (Manufacturer’s Serial Number).
D) Contact Details
Any corrections or amendments to this supplement, arising from operational use or requested changes, should be advised to STC Twenty One Limited, using the Maintenance Reporting Form at the rear of this manual, to enable any necessary remedial action to be taken.
STC Twenty One Limited The Waldorf Centre 1290 London Road Alvaston Derby DE24 8QP UK Tel: +44 (0)1332 576830 Fax: +44 (0)1332 576831 Email:[email protected]
