+ All Categories
Home > Documents > Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum...

Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum...

Date post: 14-Dec-2015
Category:
Upload: armani-silversmith
View: 216 times
Download: 1 times
Share this document with a friend
Popular Tags:
28
Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch
Transcript
Page 1: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

Introduction to Manitoba’s Oil

Industry• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

October 2011

Innovation, Energy and Mines,Petroleum Branch

Page 2: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

what is petroleum?• Crude oil, or petroleum, is an organic substance derived

from the remains of prehistoric plant and animal remains. – Also known as fossil fuels.

• Hydrocarbons are molecules containing hydrogen and carbon.

+ = ?

Plankton

Page 3: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

how was oil formed?Crude oil was formed from the remains of dead sea

creatures and plants (plankton). The organic material remains gathered on the seabed and were gradually covered by layers of sand and other sediments.

Over time these layers were compressed under the weight of sediments laid on top. The increased pressure and temperature changed the organic material, sand and other sediments into rock. The sand became sandstones or potential reservoir rocks. The organic rich layers became oil and shale or oil source rocks.

(Please see animation at http://www.absorblearning.com/media/item.action?quick=11h)

Page 4: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

where do we find oil in the source rock?

• Because oil and gas are lighter than water, they float on top of water. Oil and gas that formed in the source rock deep within the earth floated up through tiny pore spaces in the rock.

• Reservoirs contain porous rocks, such as sandstones, that allow fluids to flow through the pore spaces, that is, that are permeable.

Does this rock have good porosity?

How about permeability?

Page 5: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Page 6: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

3 phases of petroleum

Exists as a:• liquid

– crude oil

• vapor – natural gas

• solid – coal– oil sands

Page 7: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

how the oil is found...

Page 8: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

drilling rigs

• Drilling rigs use a drill stem and a drill bit to grind down through the overlaying rock to get to the oil and gas below.

• Drill rigs run 24 hours a day, 7 days a week.

• Cost to drill : (2010 average)

– Vertical well ~$450,000 + – Horizontal well ~$937,607 +

Page 9: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

4 Different drill and completion bits

Poly- Crystalline Diamond Bit

Page 10: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Horizontal DrillingA horizontal well is drilled vertically until the kick off point is reached. At this point the well is angled until it meets the targeted producing formation. The wellbore is then drilled horizontally through this reservoir. Horizontal wells provide for a greater drainage area than a conventional vertical well and therefore are generally more productive.

In Manitoba over 90% of the wells drilled are horizontal with 1 well replacing four vertical wells.

Page 11: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Vertical DrillingA hole drilled vertically into the earth usually cased with metal pipe for the production of oil or gas. Prior to 2006 most wells were drilled vertically but new drilling and completion techniques have made horizontals wells economic

Page 12: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Directional DrillingThe technique of drilling at an angle. These wells are drilled for a number of reasons: to develop an offshore lease from one platform; to reach a zone beneath land where drilling cannot be done (beneath a railroad or lake)

Directional Horizontal

Page 13: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

How is a bottle of soda similar to an oil well?

Page 14: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

artificial lift

• If the formation does not have enough pressure to push liquids to the surface some type of artificial lift system will have to be put in place.

• Types of artificial lift: pumpjacks with bottom hole pumps, submersible pumps and progressive cavity pumps.

Page 15: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Pumpjack with bottom hole pump

The purpose of a pumpjack is to convert circular motion into up and down motion to control and operate the bottom hole pump.

Page 16: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

so now what?

• Okay, the fluid is to surface, now what?

– Is it a saleable product?

– Can you put this fluid directly into your car?

– What actually comes out of the ground?

Page 17: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

emulsion

• Did you know that oil and water really do mix?

Emulsion after being shaken

Less than 1 minute later

•Emulsion is a mixture of oil, water and gas.

Page 18: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

what is a battery?

• If you’re thinking Duracell™ or Energizer ™ you are way off!

?

Page 19: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

battery

• "battery" means a system or arrangement of tanks or other surface equipment that receives fluid from, or delivers fluid to, one or more wells, and includes an injection plant, a pump station and equipment or a device designed to separate the fluid into oil, gas and water and to measure the amount of oil, gas and water; The Oil and Gas Act

Tundra Sinclair 3-4-8-29 WPM Battery

Page 20: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

what is done with the oil?• When the crude oil is clean it is ready to be

hauled to a pipeline and sold.

Sales shipping line Enbridge pipeline tank farm outside Cromer, MB

Page 21: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

what is done with the water?• The water that is separated out of the emulsion is salt water, also

called brine.• Extreme care must be given to its disposal.• Salt water is re-injected into the formation, which helps restore the

reservoir pressures.

The re-injection process is also called waterflood or secondary recovery.

Page 22: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Mineral Rights & Surface RightsMineral Rights: It is the right of the owner to exploit, mine, and/or produce any or all of the minerals lying below the surface of the property.Crown Mineral Rights – 100% of the mineral ownership belongs to the Crown (Provincial Goverment)Portional Mineral Rights - A Portion of the mineral rights are Crown and a portion are Freehold (private)Freehold Mineral Rights - 100% of the mineral ownership belongs to a private (freehold) owner.Approximately 80% of the mineral rights are owned by private individuals or companies, the remaining 20% are owned by the Crown in the right of Manitoba.

• Surface Rights - The landowner owns the surface rights to the land and may or may not also own the minerals.

Page 23: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Environment

The environment consists of everything around us, from our water to our farmland, to the sky above. These are valuable resources and it is in our own best interest to protect our land, water and air. We have to take care of our planet!

Companies are required to operate within certain guidelines that restrict how they do business. Each country is responsible for its own regulations on what is allowable.

Page 24: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Rehabilitation

• This battery site was rehabilitated and has been brought back to it’s original agricultural state. All oil field infrastructure is to be brought back to it’s original state and is regulated and administered by the Petroleum Branch.

Page 25: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

Safety

The Petroleum Branch inspectors are also Workplace Health and Safety officers who are responsible for enforcing a Safe work environment for oil field workers.

Page 26: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

• • • • • • • • • • • • • •Innovation, Energy and Mines

The Petroleum Branch was an early adopter of GIS and a large percentage of employees work with GIS on a daily basis. We use this information to plot Well locations, Oil Pools, Crown owned Mineral Rights, Flow lines, Pipelines, Oil Facilities, calculate royalties paid

to Mineral owners, create maps to post Government Lease Sales and much more. 

The majority of the Oil Industry as a whole across North America uses GIS and therefore has become much easier to view up to date information, make decisions based on

location, analyze date and submit information in a digital form.

Sample of Crown Leased Mineral Rights

GIS

Page 27: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

Daly Sinclair Oil Field

Daly and Sinclair FieldConsolidation in 2010

Page 28: Introduction to Manitoba’s Oil Industry October 2011 Innovation, Energy and Mines, Petroleum Branch.

For More information on Manitoba’s Oil Fields

Please visitwww.gov.mb.ca/petroleum

or call: Winnipeg: 945-6577

Virden: 748-4260Waskada: 673-2472


Recommended