Irrigation Pipe

The MosT AdvAnced NaMe iN waTer MaNageMeNT soluTioNsTM

DITCH ENCLOSURE PIPE FOR IRRIGATION APPLICATIONS

Water management in arid and semiarid areas is a challenge and it grows daily with increased population, climate change, expanding agriculture, and recreational use. New approaches are needed to help meet human and environmental deamands for water.

Water conservation and efficiency programs are including innovative farming techniques; such as use of pivot and drip irrigation systems versus flood irrigation systems. Every drop counts and losses to evapotranspiration and infiltration does not help.

N-12® Low Head and HP Storm pipe are specificatlly designed to meet these challenges through their structural performance, joint integrity, flow capacity, design flexibility, and economy.

ADS provides high performance products for economical conveyance of irrigation water. The use of pipe for irrigation conveyance versus earth ditches and cracked concrete lined channels reduces evapotranspiration, infiltration, and potential salt loading.

ADS Engineering Services will prepare at no cost line layouts based on provided surveys and will include a plan layout of the line, bill of materials, and fitting details.

The MosT AdvAnced NaMe iN waTer MaNageMeNT soluTioNsTM

The MosT AdvAnced NaMe iN waTer MaNageMeNT soluTioNsTM

Applications

Available 24”-60” (600-1500 mm) and meets and exceeds AASHTO M294, Type S and ASTM F2306.

Available in 12”-60” (300-1500 mm) and meets and exceeds AASHTO M330 and ASTM F2881 (12”-60”).

Structural Strength

Designed per AASHTO Section 12 Load Resistance Factor Design. The pipe will support HS-25 live loads.

Designed per AASHTO Section 12 Load Resistance Factor Design. The pipe will support HS-25 live loads.

Durability

Unaffected by soils or effluent with pH ranges of 1.5 to 14. Superior abrasion resistance with less than 20% of the material loss of other products.

Unaffected by soils or effluent with pH ranges of 1.5 to 14. Superior abrasion resistance with less than 20% of the material loss of other products.

Hydraulic Efficiency Mannings “n” = 0.012 Mannings “n” = 0.012

Light Weight Up to 30 times lighter than RCP.

Up to 30 times lighter than RCP.

Fast Installation 20’ (6 m) lengths mean fewer joints.

20’ (6 m) lengths mean fewer joints.

Joint PerformanceConforms to ASTM D3212 10.8 psi laboratory test. Can articulate the joint up to 3°.

Conforms to ASTM D3212 10.8 psi laboratory test. Can articulate the joint up to 3°.

Pressure Rating

HDB (pressure rated) liner allows for 5 psi (34.4 kPa) continuous pressure and surges up to 10 psi (68.8 kPa).

Gravity flow applications only.

LOW HEAD HP STORM

ADS “Terms and Conditions of Sale” are available on the ADS website, www.ads-pipe.comAdvanced Drainage Systems, the ADS logo, the Green Stripe, and N-12® are registered

trademarks of Advanced Drainage Systems, Inc. © 2017 Advanced Drainage Systems, Inc. #11016 07/17 MH

Advanced Drainage Systems, Inc.4640 Trueman Blvd. Hilliard, OH 43026

1-800-733-3735www.ads-pipe.com

The MosT AdvAnced NaMe iN waTer MaNageMeNT soluTioNsTM