+ All Categories
Home > Documents > James Holden Rider

James Holden Rider

Date post: 12-Nov-2014
Category:
Upload: hiero-nymus
View: 28 times
Download: 0 times
Share this document with a friend
Description:
james holden setup
1
JAMES HOLDEN : TECHNICAL RIDER James Holden to supply: - DJ Controllers - Laptop - Soundcard Promoter to supply: - 1x club mixer: Allen&Heath XONE 92 or Pioneer DJM800 ONLY (JAMES WILL USE 3x LINE IN CHANNELS, NEEDS 2 AVAILABLE AT START OF SET) - 4 x European power outlets or power board - 2 x high powered undistorted stage monitors powered by separate amplifier with volume control via the mixer's booth out Space required: - one side of the mixer: 12"x12" space (on top of a Technics with the lid on (or off) is ok) - other side of the mixer: 12"x12" space + space for laptop (14" Thinkpad). < 30cm clear space > < 80cm clear space on this side > on this side
Transcript
Page 1: James Holden Rider

JAMES HOLDEN : TECHNICAL RIDER

James Holden to supply:

- DJ Controllers- Laptop- Soundcard

Promoter to supply:

- 1x club mixer: Allen&Heath XONE 92 or Pioneer DJM800 ONLY(JAMES WILL USE 3x LINE IN CHANNELS, NEEDS 2 AVAILABLE AT START OF SET)- 4 x European power outlets or power board- 2 x high powered undistorted stage monitors powered by separate amplifier with volume control via the mixer's booth out

Space required:

- one side of the mixer: 12"x12" space (on top of a Technics with the lid on (or off) is ok)- other side of the mixer: 12"x12" space + space for laptop (14" Thinkpad).

< 30cm clear space > < 80cm clear space on this side > on this side

Recommended