1

Back to Main Page

Julie - Universal Car Emulator Programs:ESL 2 – first soldering.......................................................................................................2

Program Use

ESL 2 • ESL 2

Wiring colour codes

The LED behavior

- no jumpers – diagnostic mode - it flashes every second

- adjusting to the ECU – flashing 0,1 sec

- after adjusting it lights constantly and blinks every other second

You can buy our products and obtain technical support from our distributor. Find a distributornear you by clicking on the link: www.carlabimmo.com/our-partners

2

Back to Main Page

ESL 2 – first soldering

In Universal Julie Emulatorsolder jumpers J1, J2, J3, J4, J5 and J6

ESL 2 – second solderingIf the emulator doesn't work, do the following:

In Universal Julie Emulatorsolder jumpers J1, J2, J3, J4, J5, J6, and CAN

120R

You can buy our products and obtain technical support from our distributor. Find a distributornear you by clicking on the link: www.carlabimmo.com/our-partners

3

Back to Main Page

ESL 2 - first connection

If the emulator doesn't work, do the following:

ESL 2 - second connectionPut a 100Ω resistor on pins 2 and 4

USERenault TalismanRenault CapturRenault Megane III,Renault Clio IV,Renault Scenic III,Renault Fluence,Renault Laguna III,Renault Espace IV (Phase III and later)

You can buy our products and obtain technical support from our distributor. Find a distributornear you by clicking on the link: www.carlabimmo.com/our-partners

ESL 2 Connection

ESL 2 Second Connection

Re

na

ult

ES

L 2

4

Back to Main Page

Correct functioning of the steering wheel lock:

1. The diode on the tachometer blinks fast2. Insert the card into the slot.3. The lock is removed4. The engine can be started using 'Start&Stop' Button.

Damaged steering wheel lock:

1. The diode on the tachometer blinks fast (no card or wrong card)2. Insert the card into the slot. The diode lights continuously.3. The car does not respond to the 'Start&Stop' Button, the ignition cannot be switched on.

We are sure that the lock is damaged.

You can buy our products and obtain technical support from our distributor. Find a distributornear you by clicking on the link: www.carlabimmo.com/our-partners

5

Back to Main Page

Warning!!!

Due to possible construction changes of cars, check signals with multimeter in the ECU plug.

All rights reserved.Unauthorized copying, hiring, lending, public performance will be punished!

We state that we are the only authentic authors of this manual. We possess copyright of thispublication. Any trials of unauthorized copying, hiring, quoting prohibited!!! Both service and

advertisement constitute copyright and they are the subject to the protection in accordance with theAct from 4th Feb. 1994 on Copyright and Related Laws (Statute Book no. 24 position 93) and

protection on the basis of the Act from 8th June 1993 on combating an unfair competition (StatuteBook no. 47 position 211)

www.carlabimmo.com

Last updated 30.01.2018

You can buy our products and obtain technical support from our distributor. Find a distributornear you by clicking on the link: www.carlabimmo.com/our-partners