This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Installation manual: Parrot MKi + Parrot CK3100 range

The brand name KIA RIO and the KIA logo are the property of KIA MOTORS. This document is only valid for the vehicle model RIO® year 2011, excluding all other models in the same range and excluding later modifications made to the vehicle by the manufacturer. The Parrot brand name and logos are the exclusive property of Parrot SA.

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Accessories required

Disassembly 20min

Mounting kit 30min

Reassembly 20min

Testing 15min

Total 1h25min

YES +IGN

NO ISO

N/A UNIKA

FRONT LOUDSPEAKER TEL mode

ALL MUSIC mode

Fitting time (estimated) / Main features

Tools

- Phillips screwdriver

- Multimeter or Test lamp

- Wire tie

- Round file (or a knife)

"Please contact your wholesaler to purchase accessories. A list of wholesalers is available at

www.certified.parrot.com. "

Kram ref. Dealer ref.

CK range 86394 N/A

MKi range 84394X389 N/A

Photos for illustration purposes

CK range MKi range

To get the most out of your hands-free kit we recommend that you update your software regularly. The update procedure can be found at

http://www.parrot.com/usa/support/downloads

Updating

Plastic trim removal tools FACOM / BOJO

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Disassembly

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Disassembly

Using the plastic trim removal tools, firmly unclip the radio and air vent surround and place it on top being careful to disconnect the HAZARD WARNING switch.

Unscrew screws 1, 2, 3 and 4 around the radio. Pull and remove

it taking care to disconnect the connectors and aerial.

Using the plastic trim tools, unclip the cover located on the right side of

the dashboard.

Then remove the passenger side door seal.

1

3

2

4

1

2

3

4

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Using the plastic trim tools, run the cable under the head liner.

Microphone passage

Glue the bracket (supplied) to the windscreen, after having

thoroughly degreased the surface.

Run the cable replacing the seal on the passenger door.

Pass the cable into the dashboard on the right side.

Run it behind the glove box passing it underneath.

Then pass the cable towards the radio.

1

3

2

4

5 6

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Feeding the accessory cable

In the glove box, using a semi-rigid guide.

Pass the cable from the top right towards the radio.

Be careful to leave enough length.

1 2

3

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

ISO adapter

Fitting the hands-free system 1 / 2

Connect the adaptor (86394 for the CK or 84394X389 for the Mki) to the original connector

and connect all of the wires to the blue box as shown in the diagram below. Test the assembly

before reassembly and then slide everything behind the air conditioning control unit.

1

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Fitting the hands-free system 2 / 2

Glue the bracket to the top left of the screen, after carefully

degreasing the surface.

Pass the cable to the radio from the left (taking care to store the

cable along the vent).

2 3

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Testing

Before refitting the system, switch the kit on using the ignition (or by starting the car). By pushing the central knob of the remote control, check:

1 - that the menu is displayed on the screen (language or iPod etc) 2 - that the radio system is muted when the kit is in use (click in the blue box) 3 - that the sound through all speakers is properly muted 4 - that there is sound through the front speakers for spoken menus 5 - then turn off the ignition, verify that the kit turns off and that the message “goodbye” is displayed on the screen (otherwise reverse the fuses on the kit power supply harness) 6 - pair a telephone with the kit and make a call (check that both the microphone and the kit are working)

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the authorisation of Parrot SA. Pictures for information only.

Reassembly

Refit the system using the following procedure: 1 - reinstall the radio reconnecting the adaptor and the antenna 2 - refit the 4 screws (1, 2, 3 and 4) around the radio 3 - clip the cover back on with the air vents (TAKE CARE not to cut the cable) 4 - refit the right dashboard panel