TURBO PLUS 17/21/25/30 D
TURBO PLUS - 17D (19.8kW)TURBO PLUS - 21D (24.4kW)TURBO PLUS - 25D (29.1kW)TURBO PLUS - 30D (34.9kW)
CTX-1500GRT
CTR-5500GR
KITURAMI
TURBO OIL BOILER
1
[ INDEX ]
03 Precautions for safety
04 Check the following before start-up
05 Features
07 Major Conponents and Their Names
10 How to operate the boiler
14 Cautions during operation
17 Servicing the boiler
18 Boiler Management
19 Maintenance of Boiler
20 Installation Method
24 Trubleshooting
27 Specification
2
3
4
5
■ DHW System (Foced convection by circuration pump)
☞ POINT 1
☞ POINT 2
◆ Anti-corrosion effect in pure cupper
◆ Feed back system in DWH. inlet
6
■ TURBO OIL BOILER PLUS MODEL
AIR VENTPRESSURE GAUGE
EXPANSION TANK
LINE COOL WATER
LINE COOL WATER
SUPPLY PUMP &CIRCURATION PUMP
FILTER IN HEATING LINE
AUTO SENSOR IN COOL WATER
MAIN CONTROLER
OIL BUNER
3 WAY VALVE
HEATING SUPPLY
HEATING RETURN
DRAIN OR HEATING RETURN
ELECTRONIC PUMP OR GEAR PUMP
SUPPLY VALVE
TURBO PLUS -17 TURBO PLUS -21/25/30
7
■ CONTROLER [ CTX-1500GRT ]
4 Burner LED indicate Burner operation
5 Power LED indicate Electonic Power
2 Boiler Temp. LED indicate Heating Water Temp.
3 Circuration LED indicate Pump operation
NO items Fuction
1 Poewr Switch Main Power ON/OFF Switch
POWER5
CONTROL
1꺼짐(OFF)
POWER/RESET
켜짐(ON)
전원/재가동
OIL
COMPUTERTOTAL
34
2WATER TEMP.
너버
전 원
BURNER
CIRCULATION
순 환
8
9
10
11
12
13
14
15
16
17
18
Maintenance of Boiler
※ Receive regular inspection by once or twice a year※ clean the boiler as example as used to brush
flue
cover
silencer
Remove sludge andmoisture in oil tank
Change a filter by onceor twice a year
Wipe out plumbling by steel brush
※ Caution : Clean the boiler when stop completely!!!
Wipe out plumbling by steel brushWipe out plumbling by steel brush
19
● 보일러 가동중에 에어벤트에서 물이 일부 토출될 수
있으니 바닥 까지 호스를 연결해 주세요.
(이때 에어가 원활히 빠질지 있어야 합니다.)
● 보일러 안전변에 드레인을 바닥 하수관까지 호스를
이용하여 연결해 주세요.
Secure space for maintenance
Secure at least 60cm from the wall and 60cm from the ceiling respec tively
Connect a drain -hose and the outlet of safty valveConnect a drain -hose and the outlet of air vent
Identify drain in boiler
Installate horizontality a boiler
Do not fill up the hole where is situated the bottom
Installation Method
20
연결이 부정확하면 보일러 가동에 문제가 발생할 수 있습니다.
○ Electromagnetic pump (TURBO PLUS - 17D)
○ Gear pump (TURBO PLUS - 21/25/30D)
※주의 : 오일탱크를 전자펌프보다 반드시 높게 설치 하여 주세요.
Installation Method
※ installate a higher oil tank than the eltromagnetic pump.
Connecting method of oil line
Gear pumpde-oiler
filtertank
6m
Gear pump
filter
4m
[ No more than 4m !! ]
tankCheck
Single pipe system Double pipe system
[ No more than 6m !! ]
Oil tank is higher than the gear pump : single or double pipe system
Oil tank is lower than the gear pump : double pipe system
There is possible that the boiler cause a incorrect operation if the connection is inaccurate
① ④
② ⑩
③⑤
electomagnetic pump oil hose
oil filter extension nipple
hose bend
21
Installation Method
install the chimney with a slope of 5degree for preventing from back ofcondensed water and rain
Exhaust pipe istallation
exhaust pipe
○ Installation length of the maximum extension pipe of FE flue is whthin 5m and bending of pipe is less than 3 elbows.
○ The top of chimney must be escape from windzone ,and be not in fluenced by strong wind and rain.
○ The top of chimney keeps away from building and obstracles.
※ If you install the chimney in the windzoneit can make soot , low efficiency imperfect combusion
CAUTION!!!!
22
Check whether the oil supply valve is closed or tank is empty
Installation Method
23
24
25
26
2.2 2.7 3.1 4.1
25
25
TURBO-17D TURBO-21D TURBO-25D TURBO-30Ditems
Specification
Out put
Fuel consumption
Heating surface
Efficiency
Max pressure
Water storage
2.5
Heating inlet
Heating outlet
DHW inlet/outlet
Drain
Chimney con.
Power
Pump
SPEC
UNIT
27