A Cassette 1

➊ Pull up left cover 1 lever and open left cover 1.

KM-3050/4050/5050

B Cassette 2

➊ Open left cover 2.

C Optional Cassettes 3 and 4

➊ Open left cover 3.

Location Indicator

Paper Jam Location

A Cassette 1

B Cassette 2

C Cassette 3 or 4 (Option)

D MP Tray

E Inside the left cover 1, 2 or 3

F Duplex unit

G Document Processor (Option)

Clearing Paper Jams

If a paper jam occurs, the touch panel will display Paper misfeed and the machine will stop. Refer to these procedures to remove the jammed paper.

Jam Location Indicators

If a paper jam occurs, the location of the jam will be displayed by the alphabet, which corresponds to the specific component in the machine as the following figure with clearing instructions.

➋ Remove the jammed paper.

➌ Pull out cassette 1.

➍ Remove the jammed paper. If the paper tears, remove every loose scrap from inside the machine.

➎ Push cassette 1 back in place securely.

➏ Press the specified position to close left cover 1.

➋ Remove the jammed paper.

➌ Pull out cassette 2.

➍ Remove the jammed paper. If the paper tears, remove every loose scrap from inside the machine.

➎ Push cassette 2 back in place securely.➏ Close left cover 2.

➋ Remove the jammed paper. If the paper tears, remove every loose scrap from inside the machine.

➌ Pull out the cassette in use.

➍ Remove the jammed paper.➎ Push the cassette back in place securely.➏ Close left cover 3.

D MP Tray

➊ Remove all papers from the MP Tray.

E Inside the Left Covers 1, 2 and 3

➊ Open the left cover where the paper is jammed inside.

➋ If a paper is jammed inside, lift the lever to remove the paper.

➋ Remove the jammed paper. If the paper tears, remove every loose scrap from inside the machine.

➌ Close the left cover.

F Duplex Unit

➊ Pull up left cover 1 lever and open the left cover.

➋ Remove the jammed paper.

➌ Lift the duplex unit and remove the jammed paper.

➍ Press the specified position to close left cover 1.

Precautions of the Paper Jam

• Do not reuse jammed papers.

• If the paper tears during removal, be sure to remove any loose scraps of paper from the machine inside. Scraps of paper left in the machi-ne could cause subsequent jamming.

• Discard the paper that jammed in the optional document finisher or 3,000-sheet capacity document finisher. The page which jam has occurred will be printed again.

• CAUTION Never use sharp tools like knifes, screwdrivers or cutters to clear paperjams. Be aware of rings or watches as well.

• CAUTION Do no store paperclips or staples on any device.

• CAUTION High voltage is present in the charger section. Take suffi-cient care when working in this area, as there is a danger of electrical hock.

• CAUTION The fixing unit of this product is extremely hot. Take sufficient care when working in this area, as there is a danger of getting burned.

D Paper Feed Unit

➊ Open left cover 1.

➋ Remove the jammed paper. If the paper tears, remove every loose scrap from inside the machine.

➌ Open front cover.

➍ Turn green knob (A1) clockwise.

➎ Remove the jammed paper. If you cannot remove the paper, proceed with the next step.

➏ Pull out paper feed unit (A2).

➐ Open paper feed unit cover (A3) and remove the jammed paper.

➑ If the paper is torn, pull paper feed unit (A2) all the way out and lift it slightly to remove the paper.

➒ Remove the jammed paper. If you cannot remove the paper, proceed with the next step.

❿ Push paper feed unit (A2) back in place, and close front cover.

⓫ Press the specified position to close left cover 1.

G Optional Document Processor

➊ Remove the original from the original tray.

➋ Open the document processor top cover.

➌ Remove the jammed original. If the original tears, remove every loose scrap from inside the machine.

If it is difficult to remove the original, turn the feed dial. The original will be pushed to a place where it is easier to remove.

➍ Lift reverse unit.

➎ Remove the jammed original. If the original tears, remove every loose scrap from inside the machine.

➏ Replace reverse unit, and close the docu-ment processor top cover.

➐ Reload the originals on the document processor tray.

Duplex Unit and Cassette 1

➊ Pull up left cover 1 handle and open left cover.

➋ Remove the jammed paper.

➌ Lift duplex unit and remove the jammed paper.

➍ Pull out cassette 1 and remove the jammed paper. If the paper tears, remove every loose scrap from inside the machine.

➎ Push cassette 1 back in place securely.

➏ Press the specified position to close left cover 1.

KM-3050/4050/5050

Location Indicator

Paper Jam Location

A Cassette 1

B Cassette 2

C Cassette 3 or 4 (Option)

D MP Tray

E Inside the left cover 1, 2 or 3

F Duplex unit

G Document Processor (Option)

Clearing Paper Jams

If a paper jam occurs, the touch panel will display Paper misfeed and the machine will stop. Refer to these procedures to remove the jammed paper.

Jam Location Indicators

If a paper jam occurs, the location of the jam will be displayed by the alphabet, which corresponds to the specific component in the machine as the following figure with clearing instructions.

Precautions of the Paper Jam

• Do not reuse jammed papers.

• If the paper tears during removal, be sure to remove any loose scraps of paper from the machine inside. Scraps of paper left in the machi-ne could cause subsequent jamming.

• Discard the paper that jammed in the optional document finisher or 3,000-sheet capacity document finisher. The page which jam has occurred will be printed again.

• CAUTION Never use sharp tools like knifes, screwdrivers or cutters to clear paperjams. Be aware of rings or watches as well.

• CAUTION Do no store paperclips or staples on any device.

• CAUTION High voltage is present in the charger section. Take suffi-cient care when working in this area, as there is a danger of electrical hock.

• CAUTION The fixing unit of this product is extremely hot. Take sufficient care when working in this area, as there is a danger of getting burned.