Lab Equipment and Safety PPTClass Collaboration
3rd Period
Group Names
Abbi Pearce Mackenzie Mayo Faith Briery Amoni Coleman
Graduated Cylinder Used to measure the volume of liquid.
Hot Plate
A flat heated surface generally used to heat glassware or its contents.
Digital Scale
Electronic weighing machine used to measure mass.
Clay Triangle A piece of laboratory equipment used in the process of heating
substances by a bunsen burner.
Waiverly Muniz, Daniela Palacios, Jessica Hernandez.
Pipet a slender tube attached to or incorporating a bulb, for transferring or measuring out small quantities of liquid, especially in a laboratory.
Bunsen Burner a small adjustable gas burner used in laboratories.
Test Tube a thin glass tube closed at one end, used to hold small amounts of material for laboratory testing or experiments.
Scoopula Scoopula is a brand name of a spatula-like scoop utensil used primarily in chemistry lab settings to transfer solids
Group NamesMisty, Marissa, Marrissa, Shelbie, Brieanna
Test Tube Stand A test tube stand holds test tubes
Test Tube Clamp This test tube holder, or clamp, is 6-1/5 inches long with finger grips. Holds any size test tube. The test tube holder is used to hold test tubes when they are hot and untouchable.
Florence Flask A florence flask is used to hold liquid chemicals
Evaporating Dish Evaporating dishes are used to evaporate excess solvents - most commonly water - to produce a concentrated solution or a solid precipitate of the dissolved substance. Most are made of porcelain or borosilicate glass.
Group Names Elijah Feliciano, Keoni Ramo, Rodney Degraffenreed, Jordan Garza, Nevada Cation
Beaker A beaker is a glass container that is used to measure liquids.
Burette A graduated glass tube with a tap at one end
Eye Wash Station A piece of equipment used to wash out the eyes if chemicals get into them.
Plastic Wash Bottle Plastic wash bottle is a squeeze bottle whose contents can be forced out through a narrow hole at the top by squeezing the bottle.
Litmus Paperpaper stained with litmus, used to indicate the acidity or alkalinity of a substance. Blue litmus paper turns red under acid conditions, and red litmus paper turns blue under alkaline conditions.
Group namesIan Curry,Noah Reyes , Ryan Bailey , Kyle schwartz, Aaron Treto
Ring Stand
Iron Ring An iron ring is attached to a ring stand and is used to support laboratory equipment above the work surface. Wire gauze is placed on top of the iron ring to support beakers and flasks when heating them.
Crucible Bowl to put hot chemical in
Group namesIsaiah Knight
Kyle Sweeney
Garrett Klinger
Dalton Derr
Wire Gauze A thin translucent fabric of silk, linen or cotton.
Erlenmeyer Flask A conical, flat-bottomed laboratory flask with a narrow neck.
Lab Emergency Shut Off A safety switch that shuts off all of the gas and water in the room.
Bottle and dropper A glass tube with a hollow rubber bulb at one end and a small opening at the other, for drawing in a liquid and expelling it in drops.
Mortar and PestleA mortar and pestle is a device used since ancient times to prepare ingredients or substances by crushing and grinding them into a fine paste or powder.
Group 1 - Lab Safety Rules
1. Always wear safety goggles.
2. Keep long hair tied back.
3. Wear closed toe shoes.
4. Don’t wear jewelry.( Necklaces, rings, large earings, braclets)
5. Follow directions.
6. Wear long pants.
7. Behave.
8. Pay attention to the teacher.
9. Don’t eat in the lab.
10. Dont use your phone during an experiment.
How to Read a Chem Label and SDS 0 = minimal hazard
1 = slight hazard
2 = moderate hazard
3 = serious hazard
4 = severe hazard
Group 2 - Lab Safety Rules● Always have hair up when doing a experiment ● Have proper clothes● No jewelry ● Clothes shoes● No horse playing● Clean mess afterwards● Pay attention to directions ● Wear protective gear ● Do not taste or smell any chemicals●
How to Read a Chem Label and SDSFor a chemical label read the description for the number and colors.
The SDS explains how dangerous the chemical is.
Group 3 - Lab Safety Rules● No horse play● Put your hair up● Always wear closed toed shoes● Don't wear long sleeve shirts that dangle over your hands● Always wear goggles● Don't wear dangly jewelry ● Always follow the teachers instructions● Always tell the teacher if you injured yourself ● Always tell the teacher if you break a glass or spill a chemical
How to Read a Chem Label and SDSOn a SDS the red part of the diamond means fire hazard, the blue is health hazard, the yellow is reactivity and the white is special. There is a number in each color from 0-4, 4 being the most hazardous and 0 being the least hazardous. Just look at the picture to the right it is color coded the way it would be in the SDS.
Group 4 - Lab Safety RulesWear closed toe shoes
Wear long sleeved shirt
Wear pants
Put up long hair
Wear safety goggles
Listen to directions
How to Read a Chem Label and SDSChem Label- red=flammability,blue=health,yellow=reactivity,white=special.
On a scale of 0-4, 0 being the least serious 4 being the most serious.
Group 5 - Lab Safety Rules
How to Read a Chem Label and SDS
blue= health hazard
red= fire hazard
yellow= reactivity hazard
white= special
Group 6 - Lab Safety Rules1. Wear closed toed shoes2. Appropriate clothing ex Goggles, aprons ect. 3. No dangling jewelry4. Keep your hair out of the way5. Always be supervised 6. No playing in the lab7. Tell your teacher if you break or spill something
How to Read a Chem Label and SDS