LADDERS AND STAIRWAYS TRAINING

A competent person must train each employee in the following areas, as applicable:

The nature of fall hazards in the work area

The correct procedures for erecting, maintaining, and disassembling the fall protection systems to be used

The proper construction, use, placement, and care in handling of all stairways and ladders

The maximum intended load-carryingcapacities of ladders

Training

There must be a stairway or ladder at points of access where there is an elevation break of 19 inches or more.

At least one point of access must be kept clear.

19 inches

Break in elevation

Stairway or Ladder

Stairway Construction

RISER-The part of the stairs that will help you accomplish the height

THREADS-The length of plate

STRINGER-The part of the stairs that will hold all the weight

Where doors or gates open directly on a stairway, provide a platform that extends at least 20 inches beyond the swing of the door.

Platforms and Swing Doors

Stairways landings must be at least 30 inches deep and 22 inches wide at every 12 feet or less of vertical rise

Unprotected sides of landings must have standard 42 inch guardrail systems

Stairway Landings

Landing

Stairways

Uniform riser height and tread depth

Variations not over 1/4 inch for any stairway

Key Components forStairway Safety

Treads Rails

Handrails Stair rails Guardrails

Landings and Platforms

Stairway-Components

Stairway Handrails & Guardrails

Stair rails at least 36” from tread to top of rail

Midrails, screens, mesh, etc provided between top rail and the stairway steps

If screens/mesh is used, it must enclose entire opening

Rails must be able to withstand a force of 200 pounds

Handrail and Top Rail Strength

Handrails

Stairways with four or more risers, or higher than 30 inches, must be equipped with at least one handrail.

The stairway to this platform has more than 4 risers and is not guarded. The platform requires guarding.

Safety in Housekeeping

One way communication

Two way communication

Instructions and Communications

IS THIS SAFE ??

IS THIS SAFE ???

Fall Protection

809 fatal falls in 2006

Fatal falls rise 15 percent

Falls from ladders and roofs still account for the majority of falls

Fall protection must be provided when working over dangerous equipment and machinery

Injuries and Fatalities

24,882 injuries, nearly half (11,570) are lost workday injuries

Ladders-Accident

Near Energized Electrical Equipment

If using ladders where the employee or the ladder could contact exposed energized electrical equipment, they must have nonconductive siderails such as wood or fiberglass.

This is an unsafe condition

Accident

Carpentry Laborer Broke His Arm When He Fell from a Ladder on a Construction Site Receives $150,000 Settlement

Plaintiff was working for a subcontractor hired to do framing work, the framers had just completed installing the plywood on the second floor and were accessing the second floor by way of an A-frame ladder . As framer stepped from the second floor to the first step of the ladder, the ladder tipped over and he fell hard to the concrete floor below and suffered a broken arm injury. The company breached their duty to manage safety on the work site by having subcontractors access second floors via a-frame ladders instead of straight ladders, and failing to have ladder way openings on the second floors..

Is this safe ???