Oliver Duguid CLD 1

Landscape Digital Design

Oliver DuguidCLD

Oliver Duguid CLD 2

Method of Construction

Information Board

Rectangle created one meter from the ground –this will form the main board (Dimensions –1200mm x 1200mm)

Shape was extruded 40mm (width).

Frame was constructed by drawing the profile andagain extruding it 40mm.

This frame was given a ‘fillet’ to curve the outer edge.

Oliver Duguid CLD 3

Method of Construction

Steel Supports

Spline to form basis of the legs.

Two circles created, snapping the centre to the ends of the splines.

Loft tool used to create the 3D legs. The two circles forming the cross-sections and the spline forming the path the loft will follow.

Additional detail was added –where the board is attached to the legs.

Oliver Duguid CLD 4

Method of Construction

Board cover

The profile was created using two splines and two lines.

These were connected using the ‘Region’ tool which unifies the linesand creates a surface between them.

This surface was then extruded the desired distance.

The detail was created by subtracting 3Drectangles which intersected the mainstructure. Board detail

Oliver Duguid CLD 5

Method of Construction

Fixing details

These fixings where created by makingcopies of the board and the roof and usingthe ‘subtract’ tool to remove the ends of thefixings I did not need.

This method ensures that the fixings are trulytouching the edges of the holding surfaces.

Rendered detail of the board fixings

Oliver Duguid CLD 6

Initial Renders 1

Oliver Duguid CLD 7

Initial Renders 2

Oliver Duguid CLD 8

Photomontage 1

Created by saving the render as a .tiff with alpha which enables the renderto be isolated in Photoshop.

In Photoshop the render was placed in the scene, a shadow added which climbsthe wall (see Photomontage 2 also).

Oliver Duguid CLD 9

Photomontage 2