1. Wear Safety Equipment. 2. Keep hands and feet clear. 3. Beware of flying objects. See back for Pin Removal / Insertion specifications and recommended Slide Sledge® tool kit. Prior to removing any pins or parts refer to Manufacturers Service manual for proper procedures for securing and stabilizing equipment. Large Track-Type Tractor Application Chart Operating Weight: 84,500 - 106,000 lb. MACHINE MODELS CAT D8, D9 1 2 3 4 5 6 7 8 9 10 11 Ripper Tip/Shank Protector Carriage Pin/Tool Bar Pin Cylinder Pin Rod End Ripper Tilt Lift Cylinder Pin Ripper Lift Tilt Cylinder Pin Ripper Lift Tilt Cylinder Pin Tilt Cylinder Pin Push Arm Pin Hard Nose Pin (Install Only) Equalizer Bar to Roller Frame Pin (Note: Item# 5, 6 and11 not visible in image) 1 2 3 4 5 6 7 8 9 10 11
Transcript
1. Wear Safety Equipment.2. Keep hands and feet clear.3. Beware of flying objects.
See back for Pin Removal / Insertion specifications and recommended Slide Sledge® tool kit.
Prior to removing any pins or parts refer to Manufacturers Service manual for proper procedures for securing and stabilizing equipment.
Large Track-Type Tractor Application ChartOperating Weight: 84,500 - 106,000 lb.
MACHINE MODELSCAT D8, D9
123456789
1011
Ripper Tip/Shank ProtectorCarriage Pin/Tool Bar PinCylinder Pin Rod End Ripper TiltLift Cylinder Pin Ripper LiftTilt Cylinder PinRipper LiftTilt Cylinder PinTilt Cylinder PinPush Arm PinHard Nose Pin (Install Only)Equalizer Bar to Roller Frame Pin
(Note: Item# 5, 6 and11 not visible in image)
1
2
3
4
5
6
7
8
91011
The following removal and insertion tips are manufacturer recommendations for this model. Other model track-type tractors may use similar tips and tools for similar removals. Consult with manufacturer for specific models and uses.
Removal and installation should only be performed on pins that have been properly serviced and maintained.
