Date post: | 06-Mar-2016 |
Category: |
Documents |
Upload: | lee-gibson |
View: | 228 times |
Download: | 4 times |
sections extracted from Rhino via ‘contour’ or ‘section’ command,then ‘make2D’ command
sections rationalised to create solidpanels that can be stacked to describe the overal form - remember that every line is a cut
rationalised sections overlayed toindicate complexity of form but alsoto show how the layers align perfectlyat certain points - this is critical for thenext step of joining these together
indicating a possible step to give the planes an outline or to create a ‘rib’effect on the planes
sections taken back into Rhinoand reconfigured to create new object
final render of object - next is to considerhow they are connected together in theother direction - to create a support structure