Date post: | 12-Apr-2017 |
Category: |
Education |
Upload: | paul-osborne |
View: | 109 times |
Download: | 2 times |
Step 1: Insert wires and capacitor
IMPORTANT:Do not solder yetNotice RED wire on right, BLACK on leftThe capacitor has no polarity
Step 2: Solder and trim
Take care not to melt plasticTrim capacitor leads and excess
wire
Step 3: Route wires under motor bracket
Take care not to bend the metal tabs on the motor
Step 4: Secure wires with square knot
Tie the knot close to the nylon motor bracket. The idea is to protect the motor terminals.
Step 5: Twist the red and black wires
Verify motor terminals by wiggling the red and black wires. The solder terminals on the motor should not move.