TEcHnical FEaTurEs oF THE MicroprocEssor basED lEvEl crossinG proTEcTion sysTEM n concept based on the interaction between the
2-of-3 vital processor system and the peripheral groups for train detection, roadside signals and barriers. each control processor runs the same software in fixed cycles. system faults are
detected by comparing the information between the three independent channels n Broad range of power supply system monitoring
featuresn local and remote diagnostics
zelisko hAs More thAn 50 yeArs exPerience in the Field oF rAil signAlling
Around the world, level crossings are often seen as PotentiAlly dangerous sPots for road users. in addition to co-ordinating road and rail traffic, level crossing installations must be reliable and safe but also cost-effective and economical to maintain. zelisko railway signalling technology meets all of these demands.
cusToMEr bEnEFiTsn complete product range: systems with road side signals,
half and full barrier systems, stand-alone systems, main signal covered systems with an interlocking monitoring interface
n complete system suppliern trackside led signals with self-diagnosis reduce
life-cycle costsn support over complete life-cycle
l E v E l c r o s s i n G s y s T E M s
r A i l v e h i c l e s y s t e M s
proDucT ranGEn complete level crossing protection systems
with electronic control technologyn type approved led railway signalsn single components on demand
Complete roadside signals with
different lamp technologies
e.g. incandescent lamps with
single or double filament,
double halogen lamps or LED
RBUeT Oe Diagnostic
RBUeT OeLED-Signal EU for rail applications Remote Maintenance System
Complete barriers with drives for 24 V DC supply voltage
aDDiTional FEaTurEsn easy modification in the event of alterations
and extensionsn rapid implementation of customer requirements
through simple configurationn low life-cycle costs
P-12
18-E
N 09
.2016
This publication may be subject to alteration without prior notice. A printed copy of this document may not be the latest revision. Please contact your local Knorr-Bremse representative or check our website www.knorr-bremse.com for the latest update. The figurative mark “K” and the trademarks KNORR and KNORR-BREMSE are registered in the name of Knorr-Bremse AG. Copyright 2016 © Knorr-Bremse AG. All rights reserved, including industrial property rights applications. Knorr-Bremse AG retains all power of disposal, such as for copying and transferring.
Dr. techn. Josef Zelisko, Fabrik für Elektrotechnik und Maschinenbau Gesellschaft m.b.H.
Beethovengasse 43-452340 MödlingAustriaPhone: +43 2236 409-2229Fax: +43 2236 409-2279
w w w . z e l i s k o . A t w w w . k n o r r - B r e M s e . c o M