Home > Engineering > Lissajous method

# Lissajous method

Date post: 12-Apr-2017
Category:
Upload: siva135
View: 128 times
Download: 9 times
Share this document with a friend
9
LISSAJOUS METHOD FOR FREQUENCY AND PHASE MEASUREMENT CHIRANJEEVI E RISE COLLEGE, ONGOLE
Transcript

LISSAJOUS METHOD FOR FREQUENCY AND PHASE MEASUREMENT

CHIRANJEEVI ERISE COLLEGE, ONGOLE

Measurement of Frequency by Lissajous methodThe Oscilloscope is a Sensitive indicator for Frequency and

Phase Measurements.The Lissajous Pattern Results ,when sine waves are applied

simultaneously to both pairs of deflection plates.• If One frequency is an integral multiple of other ,the pattern will

be stationary and is called a Lissajous figure.

Measurement of Frequency by Lissajous method

The Resulting Patterns depend on the integral and phase relationship between two frequencies.

Measurement of Frequency by Lissajous methodMeasurement Procedure

1. Set up the Oscilloscope and Switch off the Internal sweep(Change to Ext)2. Switch off Sync. Control3. Connect the Signal sources as shown in above fig.4. Set the Horizontal and Vertical gain Control for desired width and height

of the Pattern5. Keep freq fv Constant and Vary freq fh noting that the pattern spins in

alternate directions and changes shape.6. The Pattern stands still when ever fv and fh are in an integral ratio(either

even or odd)7. When fv=fh , the pattern stand still and is a single circle or ellipse8. When fv=2fh ,a two loop horizontal pattern is obtained.

Measurement of Frequency by Lissajous method

Measurement of Frequency by Lissajous method

Measurement of Phase by Lissajous methodProcedure

1. Set up the Oscilloscope and Switch off the Internal sweep(Change to Ext)2. Switch off Sync. Control3. Connect the Signal sources as shown in below fig.

4. Set the Horizontal and Vertical gain Control for desired width and height of the Pattern

Cont….

5. Keep fV constant and vary frequency fh noting that the pattern spins in alternate directions and changes shape.6. When two frequencies are equal and in phase, The pattern appears as a straight line at an angle of 450 with horizontal.7. As the Phase between the two alternating signal changes, the pattern changes cyclically as shown in below fig.

Cont….

Recommended