8/6/2019 LO 5-3825-270-13 EMM WD

1/12

Card 1 of 8

LO 5-3825-270-13LUBRICATION ORDER24MAY 2011

ENGINEER MISSION MODULE - WATER DISTRIBUTOR (EMM - WD)NSN 3825-01-577-2713

PN 5251894CAGEC 80195

References: TM 5-3825-270-10 and TM 5-3825-270-23&P

DISTRIBUTION STATEMENT A. Approved for public release: distribution is unlimited.

NOTICE. Copy of this lubrication order will remain with the equipment at all times; instructions contained herein are

mandatory.

REPORTING OF ERRORS

You can help improve this publication. If you find any errors, or if you would like to recommend any

improvements to the procedures in this publication, please let us know. The preferred method is to submit

your DA Form 2028 (Recommended Changes to Publications and Blank Forms) through the Internet, on

the Army Electronic Product Support (AEPS) website. The Internet address is http://aeps.ria.army.mil.

The DA Form 2028 is located under the Public Applications section in the AEPS Public Home Page. Fill

out the form and click on SUBMIT. Using this form on the AEPS will enable us to respond quicker to your

comments and better manage the DA Form 2028 program.

You may also mail, e-mail, or fax your comments on DA Form 2028 directly to the U.S. Army TACOM Life

Cycle Management Command. The postal mail address is U.S. Army TACOM Life Cycle Management

Command, ATTN: AMSTA-LCL-MPP / TECH PUBS, 6501 E. 11 Mile Road, Warren, MI 48397-5000.

The e-mail address is: tacomlcmc.daform2028@us.army.mil. The fax number is DSN 793-0726 or

Commercial (309) 782-0726. A reply will be furnished to you.

8/6/2019 LO 5-3825-270-13 EMM WD

2/12

LO 5-3825-270-13

Card 2 of 8

LUBRICATION ORDER

NOTES:

This LO is for crew (C) or field (F) maintenance. Lube intervals (on-condition or hardtime) are based on normal

operation. Lube more during constant use, and less during inactive periods.

The water distributor is not designed for use in temperatures below 33 F (0.56 C) or higher than 122 F (50 C),therefore, the same grade lubricants should be used at all time. When using a grease gun, apply lubricant to the

fitting until clean lubricant squeezes out of the part being lubricated.

Clean parts with dry cleaning solvent (SD), type II, or equivalent. Dry before lubricating. Wipe surfaces dry.

Before you start your lube service.

For equipment under manufacturer's warranty, hard time oil service intervals shall be followed. Intervals shall be

shortened if lubricants are known to be contaminated or if operation is under adverse conditions such as longer

than usual operating hours, extended idling periods, extreme dust, etc.

ALWAYS NEVER

a. Clean grease fittings before lubrication. a. Use wrong type/grade grease.

b. Use the lubrication order as your guide. b. Use too much lubricant.

Table 1. Lubricants.

Component

Approximate

Capacity Intervals

EngineOil(E

O):

OE/HDO-3

0

MIL-PRF-21

04

Manhole Cover As Required

OC-ON-CONDITION

D - DAILY

W - WEEKLY

M - MONTHLY

S - SEMIANNUALLY (6 MONTHS)

A - ANNUALLY

B - BIENNIALLY

Stowage Box

Hinge

As Required

Air Lubricator As Required

EngineOil(EO):

OE/HDO-30

MIL-PRF-2104 Water Pump 3 oz

(88.8 ml)

EngineOil(EO

):

15W-

40

MIL-PRF-2104

Engine 14 qts(13.2 L)

8/6/2019 LO 5-3825-270-13 EMM WD

3/12

Card 3 of 8

LO 5-3825-270-13LUBRICATION ORDER

Table 2. Other Fluids.

Fluid Capacity Temperature

Dry Cleaning Solvent As Required All Temperatures

Antifreeze, Ethylene Glycol

(A-A-52624, Type 1B)

14 qt

(13.25 l)All Temperatures

Table 3. Grease, Automotive and Artillery (GAA): MIL-PRF-10924.

The following components are lubricated with GAA as required at all temperatures.

Component

Approximate

Capacity Intervals

Fog Nozzle As Required OC-ON-CONDITION

D - DAILY

W - WEEKLY

M - MONTHLY

S - SEMIANNUALLY (6 MONTHS)

A - ANNUALLY

B - BIENNIALLY

H - HOURS

Hose Reel As Required

Water Turret As Required

Table 4. Total Man-Hours *Required for Service.

Distributor, Water (EMM-WD) Hours

D --

W --

M --

S --

A --

BI --

8/6/2019 LO 5-3825-270-13 EMM WD

4/12

LO 5-3825-270-13

Card 4 of 8

LUBRICATION ORDER

8/6/2019 LO 5-3825-270-13 EMM WD

5/12

Card 5 of 8

LO 5-3825-270-13LUBRICATION ORDER

8/6/2019 LO 5-3825-270-13 EMM WD

6/12

LO 5-3825-270-13

Card 6 of 8

LUBRICATION ORDER

8/6/2019 LO 5-3825-270-13 EMM WD

7/12

Card 7 of 8

LO 5-3825-270-13LUBRICATION ORDER

8/6/2019 LO 5-3825-270-13 EMM WD

8/12

LO 5-3825-270-13

Card 8 of 8

LUBRICATION ORDER

8/6/2019 LO 5-3825-270-13 EMM WD

9/12

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

By Order of the Secretary of the Army:

MARTIN E. DEMPSEY

General, United States Army

Chief of Staff

Official:

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

JOYCE E. MORROW

Administrative Assistant to the

Secretary of the Army

1110302

DISTRIBUTION: To be distributed in accordance with the initial distribution requirements for IDN 257864

requirements forLO 5-3825-270-13.

8/6/2019 LO 5-3825-270-13 EMM WD

10/12

8/6/2019 LO 5-3825-270-13 EMM WD

11/12

8/6/2019 LO 5-3825-270-13 EMM WD

12/12

PIN: 086770-000