Position the component being added to the belt, upside down and opposite of the belt wearing style — the middle section of the component (BullyBag UItra Pouch pictured) at- tachment will be po- sitioned with the top edge of the carrier VelCro edge just above the edge of the outer belt Band. Loosen the outer belt band from the main padded belt allowing some slack/ access room between the two belts. The BullyBag Bandit Belt System uses industrial VelCro, 2 Belts & physics to lock them in. You can customize the Bandit Belt System with individual components.
Transcript
Position the component being added to the belt, upside down and opposite of the belt wearing style — the middle section of the component (BullyBag UItra Pouch pictured) at-tachment will be po-sitioned with the top edge of the carrier VelCro edge just above the edge of the outer belt Band.
Loosen the outer belt band from the main padded belt allowing some slack/ access room between the two belts.
The BullyBag Bandit Belt System uses industrial VelCro, 2 Belts & physics to lock them in. You can customize the Bandit Belt System with individual components.
Seal the component onto the belt (BullyBag UItra Pouch pictured) by pressing and securing the two remaining carrier VelCro sections together. Pull any remaining slack out of the outer belt band and adjust position to preference.
Fold the component top end flap up over the outer belt, cover-ing the outer belt band.
Your BandIt Belt System component is now secure & ready for work.
Side Scribe Velcro “Soft Cover”
Each Side Scribe comes with a cover for the outer Velcro strip for protecting the strip from dirt and debris when used as a sling or messenger style application. If using the Side Scribe as a component to the Belt System, remove this cover before installing the Side Scribe on the belt. You may either discard the cover, or keep for future application use.
