8/14/2019 Lucky in Love - Tutorial http://slidepdf.com/reader/full/lucky-in-love-tutorial 1/10 Get St. Cre som I wi * "lucky" i atrick's d te pillows ething! Th ll show yo fab The wordi love with y luck and , print and ere are lot u how to c ic - to cov g can be this tutori magic to frame it to of possibi eate these r the pillo fa pplied as Luck DIY patter al! A fun our decor. hang on t lities with two differ pillow w & ric adhesi ste ex fre sewi pen scrapboo ppliqués y in n by Brass ay to add e wall, or this patter nt pillows aterials: orm or ba or appliqu burlap ve (i.e. he paint ncil brush scissors acto knife ezer paper iron ng machin cil/marker paper (op r painted ove Apple some hum even grab . and a prin ting pieces (l t n' bond) e tional) on. You ch or, roman the mod p ted versio tters/heart oose the o e and a lit dge and c to frame shamrock tion you l le bit of eate s well! ke best*
Pillow #1 - "Lucky to be loved by you" - (appliqué version instructions)
Determine the size of the pillow you will make or cover. Cut a piece of burlap to fit in the middleof the pillow. Cut a piece of fabric for the letters. Cut it big enough so all the letter will fit. Applythe fabric adhesive to the back. Print the saying. Turn the printed saying over so the words readbackwards. Using a light table or a bright, sunny window trace the letters using a pencil.
Position the burlap piece in the middle of the fabric for the front of the pillow. Pin in place and sewaround all four edges of the burlap leaving a 3/4" border. If you don't use a sewing machine, you
could also hand stitch it on. ( If you are adding the burlap to an existing covered pillow, simply whipstitch the burlap onto the pillow with small stitches in the corners and along the sides is necessary.
This way it will be easily removed later.)
"Fray" the edges pulling at the weave of the burlap.
Finish the pillow backing, slip in the pillow form or batting and sew closed!
Pillow #2 "Lucky tonight?" (stencil/paint version instructions)
Follow the same directions as above for pillow #1 but these directions will tell you how tostencil/paint instead of cutting the letters out of fabric. Print out the wording. Lay a sheet of freezerpaper over the printed letters and tape the papers in place if needed. Trace the letters. Using a mat
and an exacto knife, cut out the letters to create a stencil.
Position the stencil on your burlap piece. Using a cool iron (low heat setting), adhere the freezerpaper to the burlap (the freezer paper will "stick" slightly to the burlap with the low heat of the
iron). Paint the letters with craft paint and a brush using whatever color matches your design. Oncethe paint is dry, peel off the freezer paper.
Use the finishing instructions from above to complete your pillow.
