10/20/2014
MELBOURNE
LED LED EDITOR 2014 QUICK SETUP GUIDE
____________________________________________________________________________________________________
____________________________________________________________________________________________________ Melbourne LED Signs 402 Ferntree Gully Road, Notting Hill, VIC 3168 1300 030 468
Page 2 of 9
Step 1 Install the software named "LED Editor" on your PC / Laptop, Open and run LED Editor software after the
program has been installed. Click on "File(F)" then "New screen (N)" and then "New screen (N)" as seen in
below.
The following steps must be done when your first time using LED Editor software. The following steps will
guide you through how to set up of your LED SIGN in LED Editor Software. Please follow carefully according
to the instructions.
____________________________________________________________________________________________________
____________________________________________________________________________________________________ Melbourne LED Signs 402 Ferntree Gully Road, Notting Hill, VIC 3168 1300 030 468
Page 3 of 9
Step 2
Now enter the password as "888".
Enter your LED SIGN Parameter settings as follow:
Module: Refer to product label
Then click on Next button
____________________________________________________________________________________________________
____________________________________________________________________________________________________ Melbourne LED Signs 402 Ferntree Gully Road, Notting Hill, VIC 3168 1300 030 468
Page 4 of 9
Unit Board: 32 x16
Colour : Refer to product label
____________________________________________________________________________________________________
____________________________________________________________________________________________________ Melbourne LED Signs 402 Ferntree Gully Road, Notting Hill, VIC 3168 1300 030 468
Page 5 of 9
Width: Refer to product label
Height: Refer to product label
In additional Settings:
Scan Mode: Refer to product label
OE Polarity: Refer to product label
Data Polarity: Refer to product label
____________________________________________________________________________________________________
____________________________________________________________________________________________________ Melbourne LED Signs 402 Ferntree Gully Road, Notting Hill, VIC 3168 1300 030 468
Page 6 of 9
Once these data has been entered correctly, click Finish Button.
Step 3 The LED SIGN setting now is done. You can create your own message. The current screen has created
Program -1 for your LED Sign. Click on Text and TEXT-1 will be created. Edit you own message in the edit
Windows.
____________________________________________________________________________________________________
____________________________________________________________________________________________________ Melbourne LED Signs 402 Ferntree Gully Road, Notting Hill, VIC 3168 1300 030 468
Page 7 of 9
Step 4 After you have created your message, it is time to using USB drive to update your LED SIGN. Plug in your
USB Drive and Click on U Disk
____________________________________________________________________________________________________
____________________________________________________________________________________________________ Melbourne LED Signs 402 Ferntree Gully Road, Notting Hill, VIC 3168 1300 030 468
Page 8 of 9
LED Editor should have found your plugged in USB drive, Click on Export file.
After it is exported, LED Editor will ask it is ok to safely detach your USB DRIVE from your PC. Click yes if it is
OK.
____________________________________________________________________________________________________
____________________________________________________________________________________________________ Melbourne LED Signs 402 Ferntree Gully Road, Notting Hill, VIC 3168 1300 030 468
Page 9 of 9
Step 5 NOW you can remove your USB DRIVE and plug it into your LED SIGN. If the LED SIGN found your USB drive
and reading its data, it will display USB data, when it is done it will show finish. At this time you can remove
your USB DRIVE then the update is done for your newly created message.