MAKING STRAIGTH THROUGH LAN CABLE

MAKING STRAIGTH THROUGH LAN CABLE

ROBERTO RUBEN F. PULGAComputer Hardware and ServicingObjectives:At the end of the session the student were able to : Obtain the appropriate protective equipment are used and OHS policies and procedures followed.Follow the 1 to 2 inches standard cut of UTP cable at both end.Arrange the untwisted color coded wires Trim the untwisted wires suitable length of RJ-45Insert the wires into the RJ-45 connector into its appropriate channels

At the end of the session the student were able to : Crimp the RJ-45 connector to the UTP cableCheck LAN Cable using Tester Make a functional LAN cableObjectives:

TOOLS USED:UTP CuterCrimping

TOOLS USED:LAN Tester

MATERIALS USED: UTP Cable RJ45 ConnectorStrip 1 to 2 inches (2.5 to 5.1 cm) of the outer skin at the end of the cable wire.

Fold each pair of wires backwards to expose the core of the cable.

Orange-striped and solid orange

Green-White striped and solid green

Blue-white striped and solid blue

Cut off the core and discard

Straighten the twisted wires using 2 pair of tweezers

Arrange the untwisted wires in a row, placing them into the position, running from right to left, in which they will go into the RJ-45 connector:

Orange with a white stripe

Orange

Green with a white stripe

Blue

Blue with a white strip

Green

Brown with a white stripe

Brown

Trim the untwisted wires to a suitable length by holding the RJ-45 connector next to the wires

Insert the wires into the RJ-45 connector, making sure that they stay aligned and each color goes into its appropriate channel

Place the wired plug into the crimping tool

Follow the instructions above to crimp an RJ-45 connector to the opposite end of the cable.

Use a cable tester to assure that your cable is working properly when both ends are crimped.THANK YOU!How did you learned today?PLEASE SEE THIS VIDEO TO GUIDE YOU MORE, IN OUR LESSON!