REPLACEAllLE PIN RACKING SYSTEMPhilip Machine Co., N. Providence, R.l.
For metal finishers Philip Machine's replaceablepin system is an economical method to maximizerack life. Their detachable wire forms allow theuser to replace the holding pins within minuteswithout replacing the entire rack. There is nostripping and no burn off. Hundreds of differentwire-formed holding pins are available for attachment to plastisol- or nylon-coated fixtures.
POLYPIIOPYLDIE DIPPING BASKETSImperial Industries Inc., Belleville, Mich.
Imperial Industries' polypropylene dipping baskets are fabricated of o/16-in. thick high-impactpolypropylene copolymer. The notched Izod test ofthis material shows no break. Baskets are stockedin 12-in. diameter x 12 in. high, 10 in. x 10 in.,and 8 in. x 8 in. Custom-fabricated sizes areavailable in round, square, or rectangular shapes.Sidewalls and bottom are manually welded with3-pass welds using inert gas. Top and bottombands are placed on the exterior wall for additional sidewall support. Handles are solid polypropylene or stainless steel. These baskets offer a costsavings over stainless steel. The 12-in. basketweighs only 4 lb. Custom-fabricated baskets areavailable in 3fs-in. or Y2-in. thick high-impactpolypropylene.
Circle 160 on reader information card
/
Fixture
\
ample pins
/
MAIlIIUAL AND AlII-POWERED RACKING EGUIPM....Endura Corp., Nokomis, Fla.
Endura's line of manual and air-powered rackingequipment can increase small part racking andunracking while virtually eliminating rackingand unracking-induced carpal tunnel syndrome.Endura also manufactures custom-tension racksfor the plating, painting, and anodizing industries.
Circle 162 on reader information card
November 1999
Circle 161 on reader information card
27