Date post: | 15-Apr-2017 |
Category: |
Technology |
Upload: | itma-materials-technology |
View: | 116 times |
Download: | 2 times |
WE DESIGN AND MANUFACTURE REFERENCE
BLOCKS WITH INDUCED DEFECTS FOR INDUSTRY
Based on customer design or on own ones according to established codes, including precise placement of defects with a wide variety of piece geometries and alloy types.
Samples or blocks manufactured by ITMA Foundation are used in different industries for facilitating design and qualification of monitoring procedures, operator´s
homologation and NDT staff training.
Materials we work with:· C-Mn Structural Steels
· High T-P Steels: Cr-Mn, Cr-Mo-V· Corrosion and Wear resistant steels· Cryogenic Steels: Ni Base, 9% Ni
· Foundries· Steels for Nuclear Industry
· Armour steel plate· Alloys for Aeronautical use
DRelevant for the following Non-Destructive Tests:
· Conventional UT, TOFD and Phased Array · Radiography
· Penetrating Liquids and magnetic particles testing
· Visual Inspection
C/ Calafates 11 (Parcela L.3.4) 33417 Avilés - Asturias(Spain)
Phone.: +34 985 129 120Fax: +34 985 129 008
Contact:[email protected]
ITMA Materials Technology counts on a fully equipped set of facilities
that allows assuming the whole block manufacturing cycle, including design, bevel
machining, manual, automatic and robot welding, dimensional control and thermal
treatments.
REFERENCE BLOCKS MANUFACTURING
SERVICES FOR NON-DESTRUCTIVE TESTING:
Relevant service for: Pressure Vessels Manufacturers,
responsibility structures for petrochemical, nuclear, offshore, aeronautics or military sectors,
NDT inspection agencies and NDT Training Centres.
We include induced defects by micromachining or electroerosion, and realistic defects through
controlling welding parameters: pores, cracks, lack of fusion, slags, etc. Pilot Plants for Hydrogen
embrittlement and corrosion are also available.
CALIBRATIONVALIDATIONDEMONSTRATION
Based on customer design or on own ones according to established codes, including precise placement of defects with a wide variety of piece geometries and alloy types.
Samples or blocks manufactured by ITMA Foundation are used in different industries for facilitating design and qualification of monitoring procedures, operator´s
· Cryogenic Steels: Ni Base, 9% Ni· Cryogenic Steels: Ni Base, 9% Ni· Foundries
· Steels for Nuclear Industry· Steels for Nuclear Industry· Armour steel plate· Armour steel plate
· Alloys for Aeronautical use
Based on customer design or on own ones according to established codes, including precise placement of defects with a wide variety of piece geometries and alloy types.
Samples or blocks manufactured by ITMA Foundation are used in different industries for facilitating design and C
M
Y
CM
MY
CY
CMY
K
anuncio F. ITMA ingles.pdf 3 1/9/16 11:33