+ All Categories
Home > Documents > MCC SIEMENS Tiastar Motor Control Center

MCC SIEMENS Tiastar Motor Control Center

Date post: 01-Oct-2021
Category:
Upload: others
View: 3 times
Download: 0 times
Share this document with a friend
11
MCC SIEMENS Tiastar Motor Control Center
Transcript
Page 1: MCC SIEMENS Tiastar Motor Control Center

MCC SIEMENS Tiastar Motor Control Center

Page 2: MCC SIEMENS Tiastar Motor Control Center

Offered “As Is”

* MCC Siemens TRIASTAR, 15" Deep, Front Only, Circuit Breaker, 480V, 3 Phase, 4 Wires,60 Hz, 42K AIC, NEMA1A Enclosure, Horizontal Bus: 1200A Tin plated Copper, Vertical Bus:300A Copper, Wiring Class II Type B

7- 15" Deep, Front Only, 20" Wide Enclosure1- Three Phase Panelboard, 4 Wire, 208/120, Main Circuit Breaker, 125 Amps, 18 Circuits7- BL PB Branch CB, Standard, 1 Pole, 100A Frame @ 10KAIC, 20A Trip1- Three Phase Panelboard, 4 Wire, 480/277, Main Lugs Only, 125 Amps, 42 Circuits1- BQD PB Branch CB, Standard, 3 Pole,100A Frame @ 10KAIC, 60A Trip15- BQD PB Branch CB, Standard, 1 Pole,100A Frame @ 10KAIC, 20A Trip1- BQD PB Branch CB, Standard,3 Pole, 100A Frame @ 10KAIC, 70A Trip1- SND6 Main TM CB, Standard, 3 Pole,1200A Frame @ 50KAIC, 1200A Trip1- Shunt trip1- Single Phase Transformer, Adjacent Feeder, 7.5 KVA1- HEG Feeder TM CB, Standard, 3 Pole, 125A Frame @ 65KAIC, 80A Trip1- HEG Feeder TM CB, Standard, 3 Pole, 125A Frame @ 65KAIC, 125A Trip

Page 3: MCC SIEMENS Tiastar Motor Control Center

3- HEG Feeder TM CB, Standard, 3 Pole, 125A Frame @ 65KAIC, 100A Trip3- HEG Feeder TM CB, Standard, 3 Pole, 125A Frame @ 65KAIC, 60A Trip1- HEG Feeder TM CB, Standard, 3 Pole, 125A Frame @ 65KAIC, 40A Trip1- HEG Feeder TM CB, Standard, 3 Pole, 125A Frame @ 65KAIC, 15A Trip3- Blank Space, 20" wide, 6" high3- FVNR, CB, Size 4, 100 HP, Class II, Type B1- ESP100 Overload XClass 201- Control Circuit Transformer, 480V, 250VA1- Pull-Apart Control Terminals1- 2 Pole Interposing Relay, non-convertible contacts1 - Pilot light (RT), Label: Running1 - Pilot light (GT), Label: Off(N.C. contact or relay is automatically selected)1 - Aux. Contact, N.C., Sz 4, Class II, Type B1 - 3RB12 Overload Upgrade2 - FVNR, CB, Size 4, 60 HP, Class II, Type B1 - ESP100 Overload XClass 201 - Control Circuit Transformer, 480V, 250VA1 - Pull-Apart Control Terminals1 - 2 Pole Interposing Relay, non convertible contacts1 - Pilot light (RT), Label: Running1 - Pilot light (GT), Label: Off(N.C. contact or relay is automatically selected)1 - Aux. Contact, N.C., Sz 4, Class II, Type B1 - 3RB12 Overload Upgrade2 - FVNR, CB, Size 3, 30 HP, Class II, Type B1 - ESP100 Overload XClass 201 - Control Circuit Transformer, 480V, 250VA1 - Pull-Apart Control Terminals1 - 2 Pole Interposing Relay, non-convertible contacts1 - Pilot light (RT), Label: Running1 - Pilot light (GT), Label: Off(N.C. contact or relay is automatically selected)1 - Aux. Contact, N.C., Sz 3, Class II, Type B1 - 3RB12 Overload Upgrade1 - FVNR, CB, Size 2, 15 HP, Class II, Type B1 - ESP100 Overload XClass 201 - Control Circuit Transformer, 480V, 150VA1 - Pull-Apart Control Terminals1 - 2 Pole Interposing Relay, non convertible contacts1 - Pilot light (RT), Label: Running1 - Pilot light (GT), Label: Off(N.C. contact or relay is automatically selected)1 - Aux. Contact, N.C., Sz 2, Class II, Type B1 - 3RB12 Overload Upgrade6 - FVNR, CB, Size 1, 0.75 HP, Class II, Type B1 - ESP100 Overload XClass 20

Original Purchase Date; June 2006

Page 4: MCC SIEMENS Tiastar Motor Control Center
Page 5: MCC SIEMENS Tiastar Motor Control Center
Page 6: MCC SIEMENS Tiastar Motor Control Center
Page 7: MCC SIEMENS Tiastar Motor Control Center

UNIT NO UNIT DESCRIPTION MOTOR DATA "1 CIRCUIT BREAKER / DISCONNECT SWITCH *3 OVERLOAD PROTECTION *4

CUST SEA TYPE/SUB HT sz KW HP FLA SF RPM FRAME or DS TRIP or CLIP RNG or FUSE TYPE RNG or HTR PROG DATA

- 07FA - FCB 12 - - - - - - HEG 125 125 - - - - - -

- 07FC - FCB 12 - - - - - - HEG 125 100 - - - - - -

- 07FE - FCB 12 - - - - - - HEG 125 100 - - - - - -

- 07FG - FCB 12 - - - - - - HEG 125 60 - - - - - -

- 07FI - FCB 12 - - - - - - HEG 125 40 - - - - - -

- 07FK - FCB 12 - - - - - - HEG 125 60 - - - - - -

See General Information and Options and Notes page(s) for explanation of asterisks, option codes, legends, and detailed notes.

SIEMENS Gust: Siemens Order No: Item: 006

Proi: Drawn bv: RWH Date: 06/07/06

TIASTARMCC MCC: 1 Unit Schedule - Left

Rev: 02 09/20/06 Release Dwg No. D52635U006 Page 2L

Page 8: MCC SIEMENS Tiastar Motor Control Center

UNIT WIRING CONTROL CIRCUIT ror*2

PILOT NO DIAGRAM AUX INT DEVICES OPTION CODES NAMEPLATE INFORMATION UNIT NOTES

TY FU VOLT CPT NO NC

01FA - 52635W4 UT 2/1 120 250 3 3 GT NO RT OLG OLM R322 RIVER WATER -

COOLING PUMP 01FE - 52635W4 UT 2/1 120 250 3 3 GT NO RT OLG OLM R322 DESUPERHEATER -

WATER PUMP NO. 1 01FI - 52635W4 UT 2/1 120 250 3 3 GT NO RT OLG OLM R322 DESUPERHEATER -

WATER PUMP NO. 2

02FA - 52635W3 UT 2/1 120 250 3 3 GT NO RT OLG OLM R322 CONDENSATE TRANSFER -

PUMP NO. 1 02FE - 52635W3 UT 2/1 120 250 3 3 GT NO RT OLG OLM R322 CONDENSATE TRANSFER -

PUMP NO. 2 02FI - 52635W1 UT 2/1 120 150 1 1 GT NO RT OLG OLM R322 CHEMICAL FEED -

PUMP NO. 1 02FK - D68500FDR - - - - - - - - FEEDER -

80AMP (TR-5)

03FA - 52635W1 UT 2/1 120 150 1 1 GT NO RT OLG OLM R322 CHEMICAL FEED -

PUMP NO. 2 03FC - 52635W 5 - - - - - - - - SPACE HEATER -

PANEL BOARD 03FH 52635W5 - - - - - - - - 9KVA TRANSFORMER -

FEEDER 03FJ - 52635W5 -- - - - - - - - 9KVA TRANSFORMER -

04FA - 52635W3 UT 2/1 120 250 3 3 GT NO RT OLG OLM R322 FUEL PUMP NO. 3 -

04FD - 52635W1 UT 2/1 120 150 1 1 GT NO RT OLG OLM R322 CHEMICAL FEED -

PUMP NO. 3 04FF - 52635W1 UT 2/1 120 150 1 1 GT NO RT OLG OLM R322 CHEMICAL FEED -

PUMP NO. 4 04FH - 52635W1 UT 2/1120150 1 1 GT NO RT OLG OLM R322 CHEMICAL FEED -

PUMP NO. 5 04FJ - 52635W3 UT 2/1 120 250 3 3 GT NO RT OLG OLM R322 FUEL PUMP NO. 4 -

05FA - D68500MCB - - - - - - - D21 1200AMP -D68500MA MAIN BREAKER DETAIL11A 11

05FG - 52635W1 UT 2/1 120 150 1 1 GT NO RT OLG OLM R322 CHEMICAL FEED -

PUMP NO. 6 05FI - 52635W2 UT 2/1120150 1 1 GT NO RT OLG OLM R322 AIR COMPRESSOR -

05FK - D68500FDR - - - - - - - - FEEDER -

60AMP CTR- 2)

06FA - 52635W6 - - - - - - P3 R322 PP-1 -

52635W7 PANELBOARD FEEDER 06FC - 52635W6 - - - - - - - - PP-1 -

PANELBOARD

See General Information and Options and Notes page(s) for explanation of asterisks, option codes, legends, and detailed notes.

SIEMENS Cust:

Proj:

TIASTARMCC MCC: Unit Schedule - Right

Rev:

-� ·-

02 09/20/ 06 Release

Siemens Order No: Item:

Drawn by: RWH Date:

Dwg No. D52635U006

FACTORY USE ONLY

NOTES PUCx

-

-

-

-

-

-

-

-

-

-

-

--

-

-

-

-

-

--

-

-

006

06/ 07/ 06

Page 1R

Page 9: MCC SIEMENS Tiastar Motor Control Center

UNIT WIRING CONTROL CIRCUIT ror"2

PILOT FACTORY USE ONLY

NO DIAGRAM AUX INT

DEVICES OPTION CODES NAMEPLATE INFORMATION UNIT NOTES

TY FU VOLT CPT NO NC NOTES PUCx

07FA - D68500FDR - - - - - - - - FEEDER - -

125AMP (CITY WATER BOOSTER PUMP)

07FC - D68500FDR - - - - - - - - FEEDER - -

100AMP (WELD. OUTLET NO. 1)

07FE - D68500FDR - - - - - - - FEEDER - -

100AMP (WELD. OUTLET NO. 2)

07FG - D68500FDR - - - - - - - - FEEDER - -

60AMP CTR-3)

07FI - D68500FDR - - - - - - - - FEEDER - -

40AMP (LIFT STATION)

07FK - D68500FDR - - - - - - - - FEEDER - -

60AMP (TR-4)

See General Information and Options and Notes page(s) for explanation of asterisks, option codes, legends, and detailed notes.

SIEMENS Cust: Item: 006

Pro Drawn by: RWH Date: 06/07/06 TIASTARMCC MCC: 1

Unit Schedule - Right Rev: 02 09/20/06 Release Dwg No. D52635U006 Page2R end

Page 10: MCC SIEMENS Tiastar Motor Control Center

D21. Disconnect device with shunt trip.

OLG. 3RB12 overload relay has internal CT ground fault.

OLM. Overload relay has monostable output behavior.

R3xy. 3RH relay with minimum xNO and yNC contacts.

GT. Push-to-Test Pilot Light with green lens and OFF legend.

NO. Pushbutton with NO contact and blank or special legend.

P3. Selector Switch 3 position with blank or special legend.

RT. Push-to-Test Pilot Light with red lens and RUNNING legend.

3RB123RB12 overload relay (see Unit Options for features).

UT. Unit transformer provides control power; x/y shows primary/secondary fuse .

Some note numbers may be intentionally omitted.

SIEMENS

TIASTARMCC

Options and Notes

Gust:

Rev: 02 09/20/06 Release

Siemens Order No: Item:

Drawn by: RWH Date:

Dwg No. D526352006

006

06/07/06

Page 1 end

Page 11: MCC SIEMENS Tiastar Motor Control Center

Recommended