MICDS CAN CHALLENGE 2011Madison Wrobley and Isabella Kendall

PROCEDURE We started with hot glue gunning three

pieces of Styrofoam together to form our box We then put masking tape around the

Styrofoam because we had hoped it would provide more insulation

We thought using duct tape would help keep the can insulated, so we put it over the masking tape

PROCEDURE We then put foam paper on the inside of the

box, which did prove to help with the insulation

We wrapped aluminum foil around the can, because from our research, we learned it was a good insulator

We had to shave the sides down on the box for it to fit in the 10x10x10 cm wood container

PROCEDURE

PROCEDURE

PROCEDURE

MATERIALS

PROCEDURE

PROCEDURE

PROCEDURE

PROCEDURE

MATERIALS