3
Cisco® Video Conferencing Video Conference The Cisco Telepresence SX / Webex Room Kit families video conferencing systems can be controlled with Mira Connect™, Aveo Systems’ smart control appliance. To integrate with Mira Connect, add the Cisco Telepresence or Cisco Webex codec to the desired room in Mira Portal (hps:// mira.aveosystems.com), enter its IP address, enter a username and password (if required) and press ‘add equipment’. Mira Connect will connect to the SX / Webex Room Kit system and show the status of the connecon. Mira Portal will show the equipment status as a green circle if the IP address is valid and the username and password are correct, otherwise the warning symbol, ! , may appear with a status message. To specify which video inputs are used on the codec, select Edit from the device’s menu, select the Video Inputs tab and enable an input, select an icon, and enter text labels for the desired inputs. This will create a display menu as shown on page 2. See the Mira Connect Administrators Guide for more informaon about using Mira Portal to set up Mira Connect. Important informaon about the integraon is summarized below. Control Interface Network connecon with SSH, using port 22. We recommend seng a stac IP address. Microphone Mute Control The microphone mute of the video conference system is controlled by Mira Connect. If there is a DSP audio conference device in the room, microphone mute is controlled by the DSP device. Room Volume Control The master volume of the codec is controlled. If there is a DSP audio conference device, room volume is controlled by the DSP device. Camera Control Mira Connect supports controlling mulple cameras. Camera presets should be created using the web interface on the Cisco Telepresence SX or Webex Room Kit series codec or the IR remote. Presets may be recalled using Mira Connect as described in this document. Supported Models Mira Connect supports at the following models of SX / Webex Room Kit products: SX10, SX20, and SX80, Room Kit Pro, Room Kit Plus, Room Kit Mini, and Room Kit. Soſtware Versions Tested with SX20 device firmware 9.3 and Webex Room Kit firmware 9.7.1. Mira Connect Integraon R SYSTEMS 192.168.80.122 Cisco Telepresence Equipment ADD Authentication failed ! Aveo Systems, Inc. 1791 West Oak Parkway Suite 8 Mariea, GA 30062 Phone: +1.678.653.7090 Fax: +1.844.fax.aveo Email: [email protected] www.aveosystems.com R SYSTEMS Mira Connect 192.168.80.122 Cisco Telepresence Equipment ADD Connection failed ! 192.168.80.122 Firmware: 9.3.1 Cisco Telepresence Equipment ADD
