+ All Categories
Home > Documents > Mira Connect Integration FSR DV-HDSS-41-Tx€¦ · The FSR DV-HDSS-41-Tx scaling video switcher can...

Mira Connect Integration FSR DV-HDSS-41-Tx€¦ · The FSR DV-HDSS-41-Tx scaling video switcher can...

Date post: 21-Jul-2020
Category:
Upload: others
View: 1 times
Download: 0 times
Share this document with a friend
2
FSR DV-HDSS-41-Tx Video Switcher The FSR DV-HDSS-41-Tx scaling video switcher can be controlled with Mira Connect™, Aveo Systems’ smart control appliance. The FSR DV-HDSS-41-Tx is a compact all-in-one soluon for small collaboraon and huddle areas. To integrate the FSR DV-HDSS-41-Tx with Mira Connect, add the FSR DV-HDSS-41-Tx to the room in Mira Portal (hps://mira.aveosystems.com), enter the IP address of the GlobalCache IP2SL and press ‘add equipment’. Mira Connect will aempt to connect to the FSR device and, if the IP address is valid and the baud rate of the IP2SL matches the FSR device, Mira Portal will show the equipment status as a green circle once the FSR device has been validated on the network. Important informaon about the integraon is summarized below. Control Interface The FSR DV-HDSS-41-Tx is controlled via an RS-232 connecon and requires a GlobalCache IP2SL (IP to serial) interface. Enter the IP address of the GlobalCache IP2SL interface as the IP address of the FSR DV-HDSS-41-Tx in Mira Portal. Port 4999 will be used for control. The GlobalCache IP2SL (part number 151.0010.001) is available as an accessory from Aveo Systems. Ensure the baud rate on the GlobalCache IP2SL matches the baud rate configured on the FSR DV-HDSS-41-Tx device. Default RS-232 sengs for the FSR DV-HDSS-41-Tx are 57,600 baud, 8 data bits, no parity, 1 stop bit, no flow control. Use a straight-through RS-232 cable that you provide as shown in the following figure. Soſtware Versions Tested with device firmware v1.5 Mira Connect Integraon R SYSTEMS 192.168.18.20 FSR Video Switcher Firmware: 1.5 Equipment ADD R SYSTEMS Aveo Systems, Inc. 1791 West Oak Parkway Suite 8 Mariea, GA 30062 Phone: +1.678.653.7090 Fax: +1.844.fax.aveo Email: [email protected] www.aveosystems.com Equipment to be Controlled Global Cache IP2SL Pin 1 Pin 5 Pin 9 Pin 6 Pin Signal 1 2 TX 3 RX 4 5 Ground 6 7 8 9 DB9 Female Pin 1 Pin 3 3.5mm Phoenix Male DB9 Female Pin Signal 1 TX 2 RX 3 Ground 3-Pin Phoenix Straight-Through RS-232 Control Cable DB9F - 3.5mm Phoenix RS-232 Connector is DB9 Male RS-232 connector is Phoenix socket RS-232 CONTROL TX RX G Pin 1 Pin 3
Transcript
Page 1: Mira Connect Integration FSR DV-HDSS-41-Tx€¦ · The FSR DV-HDSS-41-Tx scaling video switcher can be controlled with Mira Connect™, Aveo Systems’ smart control appliance. The

FSR DV-HDSS-41-Tx Video Switcher

The FSR DV-HDSS-41-Tx scaling video switcher can be controlled with Mira Connect™, Aveo Systems’ smart control appliance. The FSR DV-HDSS-41-Tx is a compact all-in-one solution for small collaboration and huddle areas.

To integrate the FSR DV-HDSS-41-Tx with Mira Connect, add the FSR DV-HDSS-41-Tx to the room in Mira Portal (https://mira.aveosystems.com), enter the IP address of the GlobalCache IP2SL and press ‘add equipment’. Mira Connect will attempt to connect to the FSR device and, if the IP address is valid and the baud rate of the IP2SL matches the FSR device, Mira Portal will show the equipment status as a green circle once the FSR device has been validated on the network.

Important information about the integration is summarized below.

Control Interface

The FSR DV-HDSS-41-Tx is controlled via an RS-232 connection and requires a GlobalCache IP2SL (IP to serial) interface.

Enter the IP address of the GlobalCache IP2SL interface as the IP address of the FSR DV-HDSS-41-Tx in Mira Portal. Port 4999 will be used for control.

The GlobalCache IP2SL (part number 151.0010.001) is available as an accessory from Aveo Systems.

Ensure the baud rate on the GlobalCache IP2SL matches the baud rate configured on the FSR DV-HDSS-41-Tx device. Default RS-232 settings for the FSR DV-HDSS-41-Tx are 57,600 baud, 8 data bits, no parity, 1 stop bit, no flow control. Use a straight-through RS-232 cable that you provide as shown in the following figure.

Software VersionsTested with device firmware v1.5

Mira Connect Integration

R

S Y S T E M S

192.168.18.20

FSR Video Switcher

Firmware: 1.5

Equipment ADD

R

S Y S T E M S

Aveo Systems, Inc.1791 West Oak ParkwaySuite 8Marietta, GA 30062Phone: +1.678.653.7090Fax: +1.844.fax.aveo Email: [email protected]

Equipment to beControlledGlobal Cache IP2SL

Pin 1Pin 5

Pin 9 Pin 6

Pin Signal12 TX3 RX45 Ground6789

DB9 FemalePin 1

Pin 3

3.5mm Phoenix MaleDB9 Female

Pin Signal1 TX2 RX3 Ground

3-Pin Phoenix

Straight-Through RS-232 Control Cable DB9F - 3.5mm Phoenix

RS-232 Connectoris DB9 Male

RS-232 connectoris Phoenix socket

RS-232CONTROL

TX RX GPin 1 Pin 3

Page 2: Mira Connect Integration FSR DV-HDSS-41-Tx€¦ · The FSR DV-HDSS-41-Tx scaling video switcher can be controlled with Mira Connect™, Aveo Systems’ smart control appliance. The

R

S Y S T E M S

On the Mira Portal Video Inputs tab, enable the desired inputs on the video switcher, and enter labels and optional descriptions, to create the video display menu for source selection.

For more information please contact our Sales Department at [email protected].

About Aveo SystemsAveo Systems is a leading provider of intuitive and easy-to-use solutions for audio, video, and collaboration, improving how systems are used and managed by customers world-wide.

DS-11011-001 Version 2018_02_12

Specifications subject to change without notice. Aveo Systems and the Aveo logo are registered trademarks. All other trademarks are the property of their respective owners.

Mira Connect Integration with the FSR DV-HDSS-41-Tx


Recommended