MOPAR B/RB COMPRESSOR/ALTERNATOR BRACKET KIT

with LATE-MODEL SAGINAW POWER STEERING PUMP161002

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 1 OF 9

an ISO 9001: 2008 Registered Company

COMPRESSOR

SAGINAWPOWER STEERING PUMP

ALTERNATOR

Bracket Systems

-TM

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 2 OF 9

2

Table of Contents

PAGES

1. COVER 2. TABLE OF CONTENTS 3. B/RB MOPAR INSTALLATION 4. B/RB MOPAR INSTALLATION (CONT.) FIGURES 1 & 1a 5. COMPRESSOR/POWER STEERING INSTALLATION FIGURES 2 & 2a 6. ALTERNATOR “B” MOUNT INSTALLATION FOR 350, 361, 383, 400 MOPAR FIGURE 3 7. ALTERNATOR “RB” MOUNT INSTALLATION FOR 413, 426, 440 MOPAR FIGURE 4 8. B/RB MOPAR BELT ROUTING 9. PACKING LIST

Bracket Systems

-TM

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 3 OF 9

3

B/RB MOPAR INSTALLATIONB: 9.98” DECK HEIGHT (350, 361, 383, 400)RB: 10.725” DECK HEIGHT (413, 426, 440)THIS BRACKET IS DESIGNED FOR MOPAR B/RB WITH LATE-MODEL SAGINAW-STYLE POWER STEERING. USE WITH OEM 2-GROOVE WATER PUMP PULLEY AND OEM 4-GROOVE CRANKSHAFT PULLEY.IF PULLEYS ARE NEEDED, THE FOLLOWING ARE AVAILABLE FROMVINTAGE AIR:735005 4-GROOVE CRANKSHAFT PULLEY735004 2-GROOVE WATER PUMP PULLEY

IDENTIFY WATER PUMP HOUSING BEFORE PROCEEDING TO COMPRESSOR/BRACKET INSTALLATION INSTRUCTIONS. THE SHORT BOSS HOUSING REQUIRES WASHERS AND/OR SPACERS TO ACHIEVE DESIRED THICKNESS OF 2 25/32” LENGTH.

NOTE: ASSEMBLE ALL BRACKETS LOOSELY TO ENGINE BEFORE TIGHTENING BOLTS. THIS WILL ENSURE PROPER ALIGNMENT OF ALL BRACKETS.

LONG BOSS

LESS THAN 2 25/32”

SHORT BOSS

2 25/32”

3-1/2” ENG BLOCK TO1ST GRV OF CS PULLEY

4-1/8” ENG BLOCK TO2ND GRV OF CS PULLEY

5” ENG BLOCK TO3RD GRV OF CS PULLEY

5-5/8” ENG BLOCK TO4TH GRV OF CS PULLEY

5-7/32” CYL HEAD TO COMP GRV 1

5-27/32” CYL HEAD TO COMP GRV 2

Bracket Systems

-TM

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 4 OF 9

4

B/RB MOPAR INSTALLATION (CONT.)

LONG BOSS COMPRESSOR/BRACKET INSTALLATION:

POWER STEERING WITH SAGINAW PUMP:

SHORT BOSS COMPRESSOR/BRACKET INSTALLATION:

WATER PUMP HOUSING WITH LONG BOSS HOUSING (2 25/32” LENGTH), WITH POWER STEERING. INSTALL COMPRESSOR/BRACKET AS SHOWN ON PAGE 5.

KIT IS DESIGNED FOR LATE-MODEL SAGINAW-STYLE POWER STEERING AND OEM BRACKET ADJUSTMENT.REMOVE WELDED NUT FROM REAR POWER STEERING BRACKET BEFORE INSTALLING COMPRESSOR REAR BRACKET AS SHOWN IN FIGURE 1, BELOW.SLOT FRONT POWER STEERING BRACKET FOR BOLT CLEARANCE. SEE FIGURE 1a, BELOW.REAR POWER STEERING BRACKET IS IN OEM POSITION. .250L SPACERS ARE NECESSARY BETWEEN FRONT POWER STEERING BRACKET AND POWER STEERING PUMP. ADD ADDITIONAL WASHERS IF NECESSARY.

*AREA TO BE REMOVED FROM POWER STEERING BRACKET*1. LOCATE ENDS OF SLOT. DRILL 1/8” PILOT HOLES FOLLOWED BY 7/16” HOLES.2. ONCE ENDS OF SLOT ARE DRILLED TO SIZE, REMOVE REMAINING MATERIAL BETWEEN HOLES CREATING THE SLOT AS ILLUSTRATED.

SCRIBE CENTERLINES AS SHOWN.

PS BRACKET CENTER AXISLATE SAGINAW

PS BRKT

FRONTVIEW

1.750” FOR REFERENCE

REMOVEWELDED

NUT

SAGINAW PUMP FEDERAL PUMP

OEM REARPOWER STEERING

BRACKET

POWER STEERING WITH FEDERAL PUMP:VINTAGE AIR POWER STEERING BRACKET KIT #161010 IS REQUIRED.

WATER PUMP HOUSING WITH SHORT BOSS HOUSING, WITH POWER STEERING. INSTALL COMPRESSOR/BRACKET AS SHOWN ON PAGE 5.

FIGURE 1a

FIGURE 1

Bracket Systems

-TM

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 5 OF 9

5

COMPRESSOR/POWER STEERING INSTALLATION

LATE-MODEL SAGINAW-STYLE

POWER STEERINGREAR BRKT

BB MOPAR FRONT COMPRESSOR BRKT

166000

5

FIGURE 2

FIGURE 2a

BB MOPARREAR COMPRESSOR

BRKT166001

WATER PUMPHOUSING

2

6

8 8

9

8

9

16

12LONG BOSS

(2 25/32”)

14

18

28

TO SHIM BOSS HEIGHT, ADD WASHERS AND OR SPACER(S)AT THESE LOCATIONS IF ADJUSTMENT IS NECESSARY.

VINTAGE AIR PROVIDES (10) ADDITIONAL WASHERS, (3)ADDITIONAL 1/4” SPACERS AND (1) ADDITIONAL 1/8” SPACER TO ADJUST BOSS HEIGHT.

*

SHORT BOSSEX. (2 9/16”)

14*

*

*

2

110

8

8

3

8

REFER TO HARDWARE PACKING LIST FOR NUMBERED PART DESCRIPTIONS.

Bracket Systems

-TM

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 6 OF 9

6

ALTERNATOR “B” MOUNT INSTALLATION FOR 350, 361, 383, 400 MOPARTHIS BRACKET IS DESIGNED FOR 383-440 MOPAR VEHICLES WITH POWER STEERING.INSTALL ALTERNATOR BRACKET AS SHOWN IN FIGURE 3, BELOW.OEM ALTERNATOR EAR BUSHING MUST BE ¾” LONG.IF TOP REAR ALTERNATOR EAR BUSHING IS LONGER THAN ¾”, IT WILL BE NECESSARY TO TRIM THE BUSHINGTO ENSURE THE BOLT WILL THREAD INTO THE ENGINE BLOCK. SEE FIGURE 3, BELOW.

ALTERNATOREAR

ALTERNATORBRACKET166003

“RB” ALTERNATORMOUNT “B” ALTERNATOR

MOUNT

FIGURE 3

BB MOPAR REAR ALTERNATOR BRKT

166003

BB MOPAR FRONT ALTERNATOR BRKT

166002

28

8

8

13 11

74

17

6

Bracket Systems

-TM

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 7 OF 9

7

BB MOPAR REAR ALTERNATOR BRKT

166003

BB MOPAR FRONT ALTERNATOR BRKT

166002

ALTERNATOR “RB” MOUNT INSTALLATION FOR 413, 426, 440 MOPARTHIS BRACKET IS DESIGNED FOR 383-440 MOPAR VEHICLES WITH POWER STEERING.INSTALL ALTERNATOR BRACKET AS SHOWN IN FIGURE 4, BELOW.OEM ALTERNATOR EAR BUSHING MUST BE ¾” LONG.IF TOP REAR ALTERNATOR EAR BUSHING IS LONGER THAN ¾”, IT WILL BE NECESSARY TO TRIM THE BUSHINGTO ENSURE THE BOLT WILL THREAD INTO THE ENGINE BLOCK. SEE FIGURE 4, BELOW.

FIGURE 4

ALTERNATOREAR

ALTERNATORBRACKET166003

OPTIONAL: AREA OUTSIDE DASH MARKS CAN BE REMOVED FOR “RB” APPLCATIONS

“RB” ALTERNATORMOUNT “B” ALTERNATOR

MOUNT

6

6

28

8

8

9

3

8 8

5

15

17

Bracket Systems

-TM

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 8 OF 9

8

B/RB MOPAR BELT ROUTING

COMPRESSOR

ALTERNATOR

WATER PUMP

SAGINAWPOWER STEERING

PUMP

VINTAGE AIR RECOMMENDED BELT LENGTHS ARE 56” ALTERNATOR AND 47 ½” POWER STEERING.

Bracket Systems

-TM

902010 REV C 5/12/14 INSTRUCTIONS, BRACKET KIT 161002, PG 9 OF 9

CHECKED BY:PACKED BY:

DATE:

CHECKLIST

BRACKET KIT161002

No.

1.2.3.4.5.

QTY.

11111

PART No.

166000166001166002166003191014

DESCRIPTION

BB MOPAR FRONT COMPRESSOR BRACKETBB MOPAR REAR COMPRESSOR BRACKETBB MOPAR FRONT ALTERNATOR BRACKETBB MOPAR REAR ALTERNATOR BRACKET383-440 MOPAR COMPRESSOR/ALTERNATOR HARDWARE KIT

1 2 3

4 5

MOPAR B/RB COMPRESSOR/ALTERNATOR PACKING LIST