® DD BluOSMounting Instructions

WHAT’S IN THE BOX

INSTALL DD BluOS

STEP ARemove the MDC Classic cover and top cover by loosening and taking out the screws holding them in place.

Installation location of DD BluOS (as viewed from the rear panel)C 390DD: First slot only from the left sideM12: Any of the three slots from the left side

STEP B1 Take note of the unique Wi-Fi MAC address (the same can be found at the

DD BluOS metal back plate). This is needed when configuring the DD BluOS.2 Remove the protective tape from the contact terminals.3 Slide DD BluOS module through the rail pushing all the way to the

corresponding connectors. 4 Make sure DD BluOS module is locked in.

Use corresponding screws to fix back into place DD BluOS module and top cover.

43

IMPORTANT NOTES

• Download “Configuring DD BluOS” from the Manuals/Downloads tab at http://nadelectronics.com/products/hifi-mdc-modules/MDC-DD-BluOS-Module• DD BluOS can be integrated to a C 390DD or M12. The reference model used in this mounting instruction is C 390DD.

2

1

WIRED CONNECTION*Connect Ethernet cable (not supplied).

WIRELESS CONNECTION*Connect dongle. If wireless connectivity is poor, connect dongle to the supplied extension cable and straighten out for better reception.

*Requires broadband router that supports Ethernet and/or WiFi standards.

BLUETOOTH CONNECTIONConnect supplied Bluetooth antenna.

Copyright 2015, NAD Electronics International, a division of Lenbrook Industries LimitedAll rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited.

No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.While every effort has been made to ensure the contents are accurate at the time of publication, features and specifications may be subject to change without prior notice.

DDBLUOS_QS_v08 - JAN 2015

CONNECT!