WS107 POLYASPARTIC 1.1 Product identifier 1.2 Recommended use of the product and restrictions on use WS107 PolyAspartic Coating Part A Resin Aspartic Acid Ester Trade name Chemical name PART A - RESIN 1. IDENTIFICATION Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6 Email: [email protected]Industrial Use, Raw material for Coatings for concrete floors None known Recommended use Non- recommended use(s) 1.3 Details of the supplier on the safety data sheet Weatherskin Corporation. Unit B 1120 44th Avenue SE Calgary, Alberta. Canada T2G 4W6 613-996-6666 403 656 9244 Company Telephone [email protected]Email www.weatherskin.com Website Emergency In case of emergency call CANUTEC 1.4 Emergency telephone number
Transcript
WS107 POLYASPARTIC
1.1 Product identifier
1.2 Recommended use of the product and restrictions on use
WS107 PolyAspartic Coating Part A ResinAspartic Acid Ester
Trade name
Chemical name
PART A - RESIN
1. IDENTIFICATION
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
Industrial Use, Raw material for Coatings for concretefloors
None known
Recommended use
Non- recommended use(s)
1.3 Details of the supplier on the safety data sheet
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
2.1 Classification of the mixture
2.1.1 Health Hazards Skin irritation Eye Irritation
Skin sensitizer
Acute Aquatic Toxicity
2. HAZARD IDENTIFICATION
Category 1C Category 2A
Category 1A
Category 3
2.2 Label Elements
Danger May cause an allergic skin reaction May cause respiratory irritation Harmful to the aquatic life with long lasting effects. Causes severe skin burns and eye damage. Causes eye irritation
Symbol
Avoid breathing dusts, mist, vapors, spray, gas. Use only in a well-ventilated area. Do not eat, drink or smoke when using this product Wash with plenty of water and soap thoroughly afterhandling Contaminated clothes are not allowed on the work area. Use gloves, avoid all contact. Keep away from heat / sparks / open flames / hotsurfaces. Keep container tightly closed
Signal word
Precautionary Statements
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
3. COMPOSITION / INFORMATION ON INGREDIENTS
Notes to Physician.
4. FIRST AID MEASURES
3.1 Mixtures
Polyaspartic coating Part A HAZARDOUS INGREDIENTS C.A.S.# WEIGHT %
136210-30-5 54914-37-3
Aspartic EsterIsophoronediamine- di-imine
70 - 90 5 - 20
IF IN EYES: Rinse cautiously with water for severalminutes. Remove contact lenses, if present and easyto do. Continue rinsing. If eye irritation persists: Get medical advice / attention
EYE CONTACT
Treatment is essentially symptomatic. FIRE-FIGHTING
If on skin or hair, take off immediately all contaminatedclothing and shoes. Rinse skin, washing thoroughly withsoap and water. Wash contaminated clothing beforeuse. If skin irritation occurs get medical attention. Washclothes before reuse.
SKIN CONTACT
IF INHALED: Remove person to fresh air. Keep at rest.Call a POISON CENTER or doctor if you feel unwell.
INHALATION
IF SWALLOWED: Immediately call a POISON CENTERor doctor / physician. DO NOT induce vomiting.
INGESTION
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
6. ACCIDENTAL RELEASE MEASURES6.1 Personal precautions, protective equipment and emergency procedures.
Avoid breathing vapors or mists. Remove all sources of ignition. Use personal protective equipmentas required. Avoid contact with skin, eyes, or clothing. Keep people away from and upwind of spill /leak. Evacuate personnel to safe areas, depending on the size of the spill, site conditions, andambient temperature. Notify managements. Call CANUTEC: 613-996-6666 for assistance and advice.
Toxic and irritating gases / fumes may be given off during burning or thermal decomposition.
5.3 Hazardous decomposition / combustion products
Carbon dioxide (CO2), Carbon monoxide (CO), oxides of nitrogen (NOx), Amines, other aliphaticfragments which have not been determined. At high temperatures, ammonia gas may be liberatedat high temperatures.
5.4 Fire-fighting instructions
Cool containers with flooding quantities of water until well after fire is out to minimize the risk ofrupture. Evacuate area of unprotected personnel. Use full protective apparel and self-containedbreathing apparatus pressure-demand, MSHA/NIOSH (or equivalent) and full protective gear.
High volume water jet. Unsuitable extinguishing media
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
6.2 Environmental precautions
6.3 Methods and materials for containment and cleaning up
Do not allow into any sewer, on the ground or into any body of water. If the product contaminateslakes, rivers or sewage, inform appropriate authorities in accordance with local regulations. Preventfurther leakage or spillage if safe to do so. Local authorities should be advised if significantspillages cannot be contained
Contain spill with dike if necessary. Absorb in suitable inert material. Sweep or scoop up usingnon-sparking tools. Place into a suitable container for disposal. After removal, flush spill area withsoap and water to remove trace residue.
7.1 Precautions for safe handling
Avoid all personal contact. Remove all sources of ignition. Use personal protective equipment asrequired. Avoid contact with skin, eyes or clothing. Do not breathe dust / fume / gas / mist / vapor/ spray. Use only with adequate ventilation. Keep away from heat, sparks, flame and other sourcesof ignition.
7. HANDLING AND STORAGE
7.2 Hygiene considerations.
Wash hands before breaks and after work. Remove soiled or soaked clothing immediately. Washcontaminated clothes before reuse. Do not eat, drink or smoke when handling this product. Removecontaminated clothing and protective equipment before entering eating areas. Avoid all contact.
7.3 Safe storage procedures
Keep away from heat. Keep containers tightly closed in a dry well-ventilated place. Empty containersretain product residue and can be hazardous. Keep / store only in original container. StorageTemperature: Minimum 5 ºC, Maximum 30 ºC. Storage period 6 months after receipt of material bycustomer. Store separate from food products.
7.4 Incompatible materials
Oxidizing agents, Acids, Isocyanates
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
8.1 EXPOSURE LIMITS
Hazardous Components(Chemical Name)
ACGIH TLV OSHA PEL NIOSH IDLH Alberta
Aspartic EsterIsophoronediamine- di-imine
Not Available Not Available
Not AvailableNot Available
Not AvailableNot Available
Not Available Not Available
8.2 EXPOSURE CONTROLS
Industrial Hygiene/Ventilation Measures General dilution and local exhaust ventilation as necessary to control airborne vapors, aerosols (e.g.,dusts, mists) and thermal decomposition products. Heating may result in generation of airbornevapors and/or aerosols.
Respiratory Protection
If vapors form, respiratory protection is recommended., The use of a positive pressure supplied airrespirator is recommended if the airborne concentration is unknown or if spraying is performed in aconfined space or area with limited ventilation., In spray applications, an organic vapor/particulaterespirator or air supplied unit is necessary.
Hand Protection
Ensure gloves remain in good condition during use and replace if any deterioration is observed. Permeation resistant gloves., Viton gloves., 4H laminate gloves., Butyl rubber gloves., Nitrile rubbergloves.
Eye Protection
Chemical safety goggles or safety glasses with side-shields., Chemical safety goggles incombination with a full face shield if a splash hazard exists.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
Skin Protection
Avoid all skin contact. Depending on the conditions of use, cover as much of the exposed skin areaas possible with appropriate clothing to prevent skin contact., Where spray mist/vapor is anticipated,permeation resistant clothing is recommended.
Additional Protective Measures
Employees should wash their hands and face before eating, drinking, or using tobacco products.Educate and train employees in the safe use and handling of this product. Emergency showers andeye wash stations should be available.
Appearance:
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State Color Odor
Liquid. Colorless or light yellow.Slight
Properties
Vapor Pressure Vapor Density Boiling Point Melting Point Flash Point PHDensity ViscosityVOC content Evaporation rate Solubility in water
No information available No information available No information available No information available No information available No information available 1.06 g/ cm3 No information available No information available No information available Negligible
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
10. STABILITY AND REACTIVITYReactivity No decomposition if stored and applied as directed.
Chemical Stability Stable under normal conditions.
Hazardous Polymerization Will not occur under normal conditions.
Conditions to avoid Moisture, high temperatures, heat, flames, sparks.
Hazardous decomposition products Carbon dioxide (CO2), Carbon monoxide (CO). Oxidesof nitrogen (NOx), Amines, other aliphatic fragments(by fire and high heat) which have not been determined.Ammonia gas may be liberated at high temperatures.
11. TOXICOLOGICAL INFORMATION
Ingredient Name
11.1 Toxicity
Rabbit, OECD Test Guideline 404, Exposure time : 4h, slight irritant
11.2 Skin Corrosion and / or irritation
Rabbit, OECD Test Guideline 405, slight irritant
11.3 Eye Damage or irritation
Aspartic Ester
Oral LD50 Acute toxicity estimate:>5000 mg/kg:>2000 mg/kg (rat) basedon a similar product
Subacute oral toxicity NOAEL:>1000 mg/kg (rat, Male / Female).Toxicological studies of a comparable product.
11.5 Repeated Dose Toxicity
Aspartic Ester
Genetic Toxicity in Vitro Salmonella/microsome test (Ames test): No indication of mutagenic effects. Chromosome aberration test in vitro: negative Genetic Toxicity in Vivo: Micronucleous tes: Negative (Mouse)
Ingredient Name
11.7 Carcinogenicity
Not Available
11.8 Reproductive Toxicity
Not information available
11.9 Specific Target Organs Effect
Aspartic Ester No carcinogenic substances as defined by IARC, NTP and / or OSHA
Isophoronediamine- di-imine Not a mutagen
Isophoronediamine- di-imine Contains no carcinogenic substances as defined by IARC, NTP or OSHA
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
12.2 Persistence, degradability and Bioaccumulation
No information available.
12.3 Other Adverse effects
Biodegradability BioaccumulationPotential
Mobility in Soil
Aspartic Ester 13%, Exposure time: 28 d. Not readily biodegradable Ecotoxicological report ona comparable product. 0%, Exposure time: 28 d. Not inherently degradable.
BCF: 1.872 The substance hydrolyzesrapidly in water. Anaccumulation in aquaticorganisms is not to beexpected.
No information available
Isophoronediamine-di-imine
Not readilybiodegradable (34%, 23 d)
Not Available Not Available
Weatherskin Corporation®, 1120 44th Ave SE, Calgary, AB T2G 4W6Email: [email protected]
Waste Disposal MethodIncinerate or dispose of unused material, residues and containers in a licensed facility in accordance with all applicable local, state and federal regulations. Do not discharge substance/product into sewage system. Do not contaminate pond, waterways or ditches with chemical orused container. The product should not be allowed to enter drains, water courses or the soil.
The information is furnished without warranty, representation, inducement, license of any kind,except that it is accurate to the best of Weatherskin Corporation’s knowledge or obtained fromsources believed by to be accurate and Weatherskin Corporation does not assume any legalresponsibility for use or reliance on same. Customers are encouraged to do their own tests.
13. DISPOSAL CONSIDERATIONS
Empty Container Precautions Recondition or dispose of empty container in accordance with governmental regulations. Do notreuse empty container without proper cleaning. Empty containers retain product residue (dust,liquid, vapor, and / or gases) and can be dangerous. Do not heat or cut container with electric orgas torch.
14. TRANSPORTATION INFORMATION14.1 Identification, UN number14.2 Shipping Name 14.3 Hazard Class 14.4 Packing Group
UN 2735 Amines Liquid, Corrosive , N.O.S 8 III
15. OTHER INFORMATIONPreparation Date MSDS prepared by
June 2nd, 2017 Weatherskin Corporation. 403 656.9244
