+ All Categories
Home > Documents > MTS200 CM200 Radio Programming

MTS200 CM200 Radio Programming

Date post: 18-Nov-2014
Category:
Upload: jeffpdf
View: 536 times
Download: 1 times
Share this document with a friend
Description:
Radio Programming guide for MTS 2000 and CM200 Radios
6

Click here to load reader

Transcript
Page 1: MTS200 CM200 Radio Programming

MTS 2000

And

CM 200

Radio Programming

Page 2: MTS200 CM200 Radio Programming

Programming MTS2000 Radios

1) Open

2) Open desired

CodePlug

3) Click on:

Tools>>Cloning>>Clone Radio

4) Click on

Page 3: MTS200 CM200 Radio Programming

5) Choose Com Port that Rib Cable is connected to

6) Watch for the serial number to change

7) Click on

8) When you get the “Write Successful” widow Click on OK , Radio is now programmed.

Page 4: MTS200 CM200 Radio Programming

Programming CM200 Radios

1) Put Toggle on Rib Cable in CPS position

2) Open 3) Click on: Edit>>Preferences… 4) Choose Com Port that Rib Cable is connected to

5) Open desired CodePlug

(Remember High Power Codeplugs CANNOT be

Used with a standard MOSCAD-L Power Supply)

Page 5: MTS200 CM200 Radio Programming

6) Click on Device>>Clone or use the button

6) CPS will read the current CodePlug

Page 6: MTS200 CM200 Radio Programming

8) Depending on the firmware in the radio, you may get this message, Click YES

9) CPS will write to the Radio

10) When you get the “Cloning the Radio was successful” widow, Click on OK . Radio is now programmed.


Recommended