NAMAÏGA Technical sheet and stage plan

Instrumentation : dj, flute , singing, electric guitar, mandola, darbuka.

DJ and flute singer Guitarist and percussion

1 stéréo XLR Line (or Jack 1/4)(for electronic sounds)2 audio sources (dj mixer and loopstation) converge to a merge box wich is brought by the musicien.

=> view of the merge box (one side) : XLR needed but the musicien also bring Jack 1/4 within case of need.

1 line with mic and stand

1 line with mic and stand

will be placed in front of the guitar amp wich is brought bythe musicien.

1 mono XLR line(for the flute)

The box and the mic are brought by the musicien

1 line with mic and stand(for percussion : Darbuka)

Electrical outlets Electrical outlets

1 chair without armrest

Back speakers Back speakers Back speakers

Preferences for the mixing :Balance between played instruments and electronics is really important for our kind of mucis.Here is our way - dj sounds constitute the base, and give the power, must not set back- the voice is integrated in the music (not in front).- all the others instruments (guitars, flute, percussion), also integrated in the music (not in front).- add reverb on voice and flute.

Stage plan

Left Center RightDj + flute Singer Guitarist + mandola + percussion(need about 4 m², no table needed, (need a mic (need about 4m2 and a chair without the dj bring it all) with stand) armrest)