ENCAP SYSTEMS INC.
“Encapsulating and Protecting building systems for a stronger
tomorrow”
NEW & OLD CONSTRUCTION
Test Equipment and Procedure
ASTM C1601 - 04 Standard Test Method for Field Determination of Water Penetration of Masonry Wall Surfaces (ASTM C1601 - 04 2004) is a pressurized water test that simulates wind
driven rain. The test measures the rate of water flow out of a closed system under a given rate of
air pressure and water flow that simulates wind speed and rainfall rate respectively.
Used by the University of Central Florida to determine the reasons for water penetrations, new and old stucco construction during heaving rains and hurricanes.
Results after ASTM Test on ENCAP SEAL on the walls at the VA hospital.
.083 Gallons/ hour intrusion
(.375 Gallons/ hour intrusion considered excellent)
The Encap Group, LLC
Application of water intrusion equipment being installed to the walls of the VA hospital prior to the application of the ENCAP SEAL System.
Water curtain attached to the wall of the VA hospital prior to the application of the ENCAP SEAL water proofing system.
Note water running down the wall prior to the application of the ENCAP SEAL system.
UCF pump equipment
EXAMPLES OF PRODUCT USE
WATER PROOFING ON WALLS AND ROOFSOUC
Water Storage Tank,
Lake Highland
Orlando, FL
Encap Seal was applied as
a roof coating this water
Tank.
As a water proof
coating on concrete /
stucco walls
Allowing heavy
lift crane to
traverse
without damage to
The coating.
INSULATED WALL PANELS
ENCAP SEAL applied to walls, Orlando Florida
SYSTEM OVER T1-11 WOOD SIDING AND OLD BRICK
Columbus, Ohio
CONCRETE STRUCTURAL REPAIRS
Retaining walls repaired without the use of concrete forms.Shell Oil Company , Cleveland Ohio
DENSE GLASS
ENCAP SEAL applied to Dense Glass without using a vapor barrier.
Tavares, Florida
ENCAP SYSTEMS INC.
“Encapsulating and Protecting building systems for a stronger
tomorrow”
www.encapsystems.com