Series PAF3000

NPP-E04-15

Process PumpNon-Metallic Exterior

(No external metal parts are used.)

Lightweight and Compact

Max. discharge flow rate: 20 l/min(Automatic operation)

Weight: 1.3 kg(air operated, without foot bracket)

116 mm

119 m

m

140 mm

Process Pump

Body materialBody material

New PFADiaphragm/Seal materialDiaphragm/Seal material

PTFE

Body material

New PFADiaphragm/Seal material

PTFE

One pump is compatible with various fluids.

One pump is compatible with various fluids.

Series PAF3000Process Pump

Series PAF3000

Large flow rateThe flow rate has been increased by 50% even

though it is almost the same size as the PA3 series.Max. flow rate: 20 l/min (automatic operation)

PPS/PFA dual constructionWithstand pressure and heat cycle performance have been increased.

ModelOperation method

Discharge flow rateAverage discharge pressurePilot air pressureAir consumption

NoiseWithstand pressureService lifeOperating fluid temperatureAmbient temperatureWeight (without foot bracket)MountingPackaging

PAF3410Automatic operation

Rc, G, NPT 1/4"1 to 20 l/min Note 2)

80 dB or less (with silencer, AN200)

1.6 kg

PAF3413Air operated

Rc, G, NPT 1/8"1 to 15 l/min Note 2)

80 dB (A) or less (excluding the noise from the quick exhaust and solenoid valve)

1.3 kg

Rc, G, NPT 3/8" female thread, 1/2" tube extension

0 to 0.4 MPa0.2 to 0.5 MPa (for 0 to 60°C)

230 l/min (ANR) or lessUp to 1 m (inside the pump is dry)

Up to 4 m (with fluid inside the pump)

0.75 MPa50 million cycles (for water)0 to 90°C (with no freezing)0 to 70°C (with no freezing)

Horizontal (mounting on the bottom surface)Clean double packaging

Main fluid: Suction/Discharge portPilot air: Supply/Exhaust port

DryWet

Specifications

Note 1) The junction shaft for the diaphragm is made of stainless steel with a resin coating.Note 2) Values in the table are measured at room temperature using clean water.

Side cover

PFA

DiaphragmDenatured PTFE

Side cover

PPS

Series PAF5000• Non-metallic exterior (no metallic parts are used.)• Body material: New PFA• Diaphragm/Seal material: PTFE• Discharge flow rate: 45 l/min (automatic operation)

Port size

Suction lift

1-16-4 Shimbashi, Minato-ku, Tokyo 105-8659 JAPANTel: 03-3502-2740 Fax: 03-3508-2480URL http://www.smcworld.com© 2005 SMC Corporation All Rights Reserved

Specifications are subject to change without prior notice and any obligation on the part of the manufacturer.

1st printing JT printing JT 130KS Printed in Japan.D-KS

This leaflet is printed on recycled paper with concern for the global environment.