Nova C Series Add Ons Nova C Single Endpiece
Product desription
Recycling
Assembly instructions Nova C Single Endpiece
p1
p2
p3-5
Nova C Add Ons Green Furniture Concept
Product descriptionAdd ons
Nova C Single Endpice
Nova C Single Endpice can pe plaged at the end of any Nova C Back configuration.
Material Ribs: Form pressed vereer treated with hard wax oil.
Material Legs: Powder coated steel.
Legs, strips, armrest, table holder and small parts are made of steel and are sorted as metal.
Recycling
Nova C Add Ons Green Furniture Concept2
Ribs and table tops are made of wood and adhesive and are sorted as combustible.
Glides are made of HDPE and are sorted as plastic.
Nova C Add Ons Green Furniture Concept3
Assembly instructionsNova C Endpice Single
Nova C Glides x2
Nova C Endpiece Leg x1 Nova C Slender Rib x7 Nova C Back Half Rib x6
Nova C Endpiece Clip x1Nova C Back Metal
Strip 90 x1Nova C Seat Metal
Strip 90 x1
Note: Due to that the assembly of this bench mostly is done with the ribs upside down we recommend you to use a blanket or simmilar to prevent damage to the ribs and metal parts.
Top Bracket x1Corner Bracket x2
Bolt A x8
Screw B x16
Screw A x94
Nova C Endpiece Cover Plate x1
Bolt B x22
Nova C Add Ons Green Furniture Concept4
Assembly instructionsNova C Endpice Single
1 2
3 4
Use bolt A to attach glides to the leg.
Use screw A to attach metal strips to the ribs. Start with the outer slender ribs, continue with the rest of the ribs.Leave the to most outwards holes on the Seat Metal strip.
Use screw A to attach the leg to the rib construction.
5 6
Attach the Endpiece whit screw B. Replace the three screws that are already in the Back Metal Strip.
Only three of the screws in the rest of the configuration should be replaced with the new screws for the endpice.
Attach the Endpiece Clip to the leg and Seat Metal strip using screw B.
Nova C Add Ons Green Furniture Concept5
Place the Nova C Endpice Cover at the end of the configuration.
Assembly instructionsNova C Endpice Single
7
Use bolt B to attach the Endpiece to the rest of the configuration through the Endpiece Clip.
8
Use screw A to attach the Endpiece to the rib on the end in ther rest of your configuration through the Endpiece Clip.
109
Attach the Top Bracket and the Corner Brackets to the Endpiece Cover using bolt B.
11
Attach the Cover plate with Screw B.Replace the three screws that are already in the Metal Back Strip.
12
Use screw A to conect the top of the Cover Plate to the Back rib.
greenfc.com