Sold as kit Including:
Aluminum Profile - 8 ft (98 7/16”)
Diffuser - 8ft (98 7/16”)
End Caps - 4 Pieces
Mounting Bracket - 4 Pieces
*Suspension kit optional
Type: Built-In
Light Source: Module 1.4
Color Temperature: 2700k/4000k
Lumen Output: 384 lm/ft
Power Consumption: 7.4 w/ft
Dimming and Non-Dimming
Dimming set to (0-10) or (1-10)
(855) 960-0606
www.centerlight.com/vs6332.IES
Designed in California by CENTERLIGHT.COM
VS. 6332Linear Fixture
! “Prior to instalation, choose a location for the power supply and make sure that it is connected to the light switch or a lighting system.”
Installation Instructions
Prepare the surface for
installation of the fixture.
1 Make the electrical
connection to the power
supply and then run the
wires to the location of the
light fixture.
2 Drill a hole into the fixture for
low voltage wires.
3
Secure the end caps and
install the mounting
brackets.
4 Install the fixture into the surface and
run the wires through the hole.
5 Secure the mounting brackets.6
PHOTOMETRIC
Instructions for the connection of electrical wires for fixtures longer than 8ft (98 7/16”)
Install the DreamLED strip on the
fixture surface and connect the
electrical wires
7 Install the diffuser.8 The fixture is ready for use. Enjoy
the light!
9176
352
529
705
1
2
Maximum Candela = 704.78 Located At Horizontal Angle = 0, Vertical Angle = 0# 1 - Vertical Plane Through Horizontal Angles (0 - 180) (Through Max. Cd.)# 2 - Horizontal Cone Through Vertical Angle (0) (Through Max. Cd.)