Objectives SOL: The student will demonstrate an understanding of basic vehicle operating procedures. Objective: *The student will utilize basic procedures and readiness techniques to enter, start, and secure the vehicle, and perform basic vehicle maintenance checks. *The student will recognize, understand, and describe the laws and procedures related to roadway signs, signals, and markings *The student will recognize and understand the function and operation of each vehicular alert or warning symbol, control device, information device, and comfort system
Transcript
ObjectivesSOL: The student will demonstrate an understanding of basic vehicle operating procedures.
Objective: *The student will utilize basic procedures and readiness techniques to enter, start, and secure the vehicle, and perform basic vehicle maintenance checks.*The student will recognize, understand, and describe the laws and procedures related to roadway signs, signals, and markings*The student will recognize and understand the function and operation of each vehicular alert or warning symbol, control device, information device, and comfort system
Journal #7PART 1: Analyze the poster. What’s the message and why do you feel it’s important? Do you think thepenalties are too harsh? Why orwhy not?
PART 2: When your done come upto the board and point at the cars that must YIELD.
9/24/2014
Under the Hood Challenge
Module 1 Quiz
Module 2
~DRIVER PREPARATION PROCEDURES~~VEHICLE CONTROL DEVICES~
~OPERATING VEHICLE CONTROL DEVICES~~VEHICLE BALANCE~
6. The top of the head restraint should be position slightly above the ears.
7. With a properly set rear view mirror, you should be able to see at least 200Feet behind the vehicle. Set the side view mirrors 15 degrees outward to reduce the blind spot and glare at night (Blindzone/Glare Elimination (BGE) Settings).
Watch Clips (BGE & 8 and 4): http://www.safeteendriving.org/media/tvpsa.php
10. Identify these items found under the hood.1) Battery2) Air Filter3) Oil Dip Stick
Write these other important items down in your workbook.a) Engine coolant Reservioirb) Wind Shield Washer Reservoirc) Engine Oil Filler Capd) Transmission fluid dipstick (A)e) Engine Oil Dipstickf) Break Fluid Reservoirg) Clutch Fluid Reservoir (M)h) Batteryi) Power Steering Fluid j) Drive Beltsk) Air Filter
Find the Part & Checking Oil
DRIVER PREPARATION PROCEDURESTopic #1
11. You could check the tire pressure weekly, engine fluids monthly, and air pressure in spare tire every 6 months.
12. How often should you change your engine oil? Every 3,000 miles or 3 months.
13. Name 5 Maintenance items that should be professionally performed every 15,000 miles.
a) automatic transmission fluidb) breaksc) cooling systemd) steering linkagee) air and fuel filters
Objectives - Conclusion SOL: The student will demonstrate an understanding of basic vehicle operating procedures.
Objective: *The student will utilize basic procedures and readiness techniques to enter, start, and secure the vehicle, and perform basic vehicle maintenance checks.*The student will recognize, understand, and describe the laws and procedures related to roadway signs, signals, and markings*The student will recognize and understand the function and operation of each vehicular alert or warning symbol, control device, information device, and comfort system
